Jump to content
SAU Community

Recommended Posts

Selling my blow off valve, been using it for 3 months.

I bought it for $350, I'm looking for $320 firm

Basically I'm selling because I want to go back to plumb back bov (greddy type s or stock bov), plus I don't want to attract cops

Erik

  • 3 weeks later...

I could say, there is no issue of idling but stalling it depends on your tuning.

After I tune my car , I have no problem with it even though say I'm running diff level of boost, the rev will play a bit but I never stall with this blow off valve.

Ok , picture below

Does it sound like every other bov or does it have its own unique song?

I currently have a Blitz DD Supersound and I'm bored of it as it sounds the same as any other. Would you know if it will be different to that one?

Low boost, it's sort of like whistling / fluttering or in between.

Mid boost , it's like gfb blow off valve

High boost, it's like 2 "blast" sound

I can't describe it any clearer than that because it's just special :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
×
×
  • Create New...