Jump to content
SAU Community

Recommended Posts

Hi all,

Was wondering, people state that when you start modifying your engine, you should get a rising rate fuel pressure regulator or something like that. How does this help? Is this something only moderate/heavy modified engines should have or will it give gains on any engine regardless of state of tune?

Cheers!

:P

Link to comment
https://www.sau.com.au/forums/topic/6678-fuel-pressure-regulators/
Share on other sites

The skylines run really rich right.

Say 10 parts air to 1 part fuel

On a mildly modified engine u can use this adjustable reg to wind the overall pressure down when on boost so that your mixtures can come back to say 12:1 more power more fuel economy :P

On a higher modified car u can use it to bump up the pressure to make your injectors squirt more so u can delay having to buy bigger units..Also a bigger fuelpump sometimes requires u to use a reg.

cheers

I may be wrong here, but I understood that a rising rate reg did the opposite.

A factory reg runs a 1:1 ratio between boost and fuel pressure, so for each psi of boost, the regulator increases the fuel pressure by 1 psi.

A rising rate reg runs 1:1-and-a-bit boost:fuel pressure, so for each psi of boost, the regulator increases the fuel pressure by say 1.1 psi. At higher fuel pressures, more fuel is injected at a given injector duty cycle. This is to stop the A/F leaning off at high boost levels.

The advantage of rising rate reg is that they can be adjusted to give a different-from-factory base fuel pressure, say 45 psi at idle instead of 40psi at idle. This is a cheaper way than fitting a set of higher capacity injectors.

I actually realised that after I posted. Because you can adjust the pressure, you can reduce as well as increase the base pressure. Therefore you could effectively lean off the mixtures a bit (on a dyno of course!) by reducing the base pressure.

Originally posted by SeriesIIGTST

Hi all,

How does this help? Is this something only moderate/heavy modified engines should have or will it give gains on any engine regardless of state of tune?

Cheers!

:D

I'll give you a straight answer to your question.

You will need a rising rate regulator if your car is producing over 215kw at the wheels.

- this is when your injectors Duty Cycle are maxed out, ie cannot supply any more fuel.

Also note that the standard fuel 'pumps' are only good for about 200 at the wheels max, and are not known for their reliability.

All you need to know about the regulator is that it can raise the fuel pressure so that when your injectors are OPEN, more fuel will come out due to the higher pressure.

You wont get any gains on a standard engine. Gains will only be realised if your injectors are too small to supply the required amount of fuel (which is around the 215rwkw mark).

just beautiful! :D

One very large point worth considering if you intend to push the stock injectors with high base pressure:

* As you increase pressure your fuel pump's maximum flow decreases.

This means if you want to wring every last bit out of the stock injectors with a rising rate you had better have the big ass 044 bosch or something similar. Some of the 900 series bosch intank pumps would be pushed very hard to supply the necessay fuel at the high pressures you need for stock injectors to get 230+rwkw.

This is an example of pressure Vs flow for the big bosch.

kgf/cm2 Flow (L/hr)

2 ------------------249

3 ----------------- 236

4 ---------------- 224

5 -------------- 206

6 ----------- 195

Originally posted by Clint32

Do you think the stock regulator will be ok to use with 550cc injectors and a 044 pump.  The injectors will have plent of spare duty cycle so it should be ok im thinking, wanting about 240rwkw.

That should be fine, 550's (6 of) are roughly 550hp worth at the same pressure. you can get a reg later if you need to.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • HFM BM57 has a "bad" knee point, IIRC. It's not the same thing as the later R chassis MC.
    • The ATTESSA is functionally identical to R34; there were a bunch of JDM models that continued ATTESSA including Fuga/Q70, Skyline/Q50, Cima etc as an option. All with Auto only and I think mostly for snow regions. AFAIK there were no AWD VR30DDTT sold in Australia - it is on my to do list to check regs for racing a LHD car in Targa/ATR/AASA/CAMS events because if I can get the auto to work it would be interesting to run a 4wd car The Ecuteck TCM tuning is the same model as their ECU tuning, they already have it for R35 and Dose's favourite, BMW. You buy "points" to allow your computer to be tuned, buy either a bluetooth (phone app) or bluetooth+USB+Key (phone and PC) dongle, and pay for a tune that will be locked to your tuner ( ). You can also access the tuning software yourself but 1. it is mega expensive and 2. these computers have a billion parameters that intersect, so how could you ever spend enough time on it to get a decent result.
    • Or, is it a case of what it is like owning an R series Skyline? NFI what the previous owner has done or fiddled with... Ha ha ha After reading through this thread, I went on a bit of a research about the Q50/Q60. Now I'm quite intrigued by them! Is the AWD in them more like a WRX where it's always AWD, or is it more like the ATTESSA in the GTRs? By the sound of this TCU tuning, this sounds like a case of someone has made some real software for it, and you just need the right piece of hardware, and then you license that specific vehicle/TCU. Or is this a case of the software will be really expensive so only a few tuners have it, and you still have to pay a license per vehicle?
    • By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
    • No, code 21 is very straightforward. It can only be the things described in that diagnostic flow. In fact it has no way of knowing that the spark plug resistance is out of spec.
×
×
  • Create New...