Jump to content
SAU Community

Recommended Posts

Take them out and get at them with a pressure hose, gerny etc

YEAH if your car is going to be used as a TAXI :headshot:

Mate i would not do that, Being a motor trimmer myself i would not advise anyone to do this. What will happen is water will eventually rust away the seat frame itself and saturate the foam which will cause it to slowly fall apart and your car will eventually always smell damp mildew will form and your arse will get wet. Also it would take days in the sun or under lights to dry.

The best thing to do is grab yourself Soap and water is the best thing to

A Bucket any interior including Leather

A Scrubing Brush forget armaroil and all that crap

Some Soap They do more bad then good...

And Some Warm Water

and start scrubing

or you could go buy some of that upholstry cleaner crap from Autoone ect and give it a go.

Cheers Bro

Take them out and get at them with a pressure hose, gerny etc

YEAH if your cars a TAXI :headshot:

Being a Motor Trimmer iwould not advise anyone to do that.

What would happen is your seat frame will start rusting causing many complications.

The Foam its self will be saturated and eventually start falling apart,mildew can start to form and your car may smell damp and your arse will get saturated for days after.

This is also a bad idea if your seats are electrical.

The best thing you can do is grab your self.

A Bucket

A Scrubing Brush

Soap

and Warm Water

This is the best thing to use on any interior upholstry including leather although you will also need to condition leather as well.

To all you guys that use armaroil and all that crap Stop your killing your interior very slowly.

Are you talking about leather? or all the plastics aswell.  

if so, then teach us Obi-wan.....

Do not use ANY silicone based product on anything in your car. When the product dries up, the silicon starts to shrink and can, eventually, dry out your dash and crack.

Only use a non-silicone, UV protectant, product just ask your car accessories supplier.

PS: Hey Jayson, How have you been? I am trying to get my car back together b4 the interstate meet up in May, so hopefully we could catch up then. :D

My Car came with pretty clean seats (luckily) but still a bit smelly and dirty.

I just grabbed a can of Interior cleaner(Kitten) and cleaned the seats with that foam spray and some warm water on a rag. they came up really good, as for protecting them, I USE SEAT COVERS!

mark :D

The new preen carpet cleaner is sensational. Spray on, wipe off with dry cloth the give a light rub with a damp cloth. Grease and oul stains just disappear.

I was going to reccommend Kenco Shift-It.

Worked a treat on all my seats and headlining.

Spray on, wipe with a damp cloth, then blot with a dry cloth to remove excess moisture.

Gentle enough to use on fabric, and strong enough to clean oil, grease and dirt scum from the engine bay.

(Not sure if I'd want to put carpet cleaner in the engine bay?)

Well I still have'nt received any more detailed shots of my car other than the auction pictures but did get my auction sheet translated by a Japanese exchange student living at a freinds house.....and guess what..."Dirty Inside" was one of the comments :)

Looks like i'm off to buy a bottle of Preen :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...