Jump to content
SAU Community

Recommended Posts

Originally posted by rob77

I didnt start this thread out to be "my car has more HP than everyone else" i just stated what figure the dynapak dyno read.

*sigh*...

Rob, we are not really saying this either. We would like cars to have more power. Makes it easier to kick Holdes and Fords. :P

But what we are saying is that we find it very strange for an engine of that calibre to pull that amount of horses with the mods that you have done.

(Is it me or is this deja vu with the mid 13 drag times?)

  • Replies 75
  • Created
  • Last Reply

Top Posters In This Topic

Originally posted by IMACUL8

Even a properly tune FMIC is only going to give you max 10 - 12 hp gain on a dyno....

I know this from experience.... as does 25GTT.... and probably a few others.....

A properly tuned FMIC (FMIC + fuel control) should give 30+ hp. I'll confirm that, so will Barrie at Barries Dyno and Steve at SST.

Originally posted by IMACUL8

Agreed... BUT i said FMIC only.....

What you really said:

Originally posted by IMACUL8

Even a properly tune FMIC

I spotted the possible confusion from a mile away, so I defined "properly tuned" to mean setup in conjunction with fuel control.

I put fuel control in my car went from 181rwhp to 219rwhp.

Nice. Same sort of gain I got.

When i put FMIC later car went from 241rwhp to 252rwhp.

And if you had "properly tuned" the s-afc to suit, there should have been another 20+ hp hiding in there.

Originally posted by Gradenko

A properly tuned FMIC (FMIC + fuel control) should give 30+ hp. I'll confirm that, so will Barrie at Barries Dyno and Steve at SST.

Aahh dont for get boost is very relative as the standard intercooler is efficient at 7psi :) the more boost u run the less efficient the ic and more gains to be had when tuned with the bigger ic

You guys should be lucky i got 26hp from turbo upgrade , 2 psi jump and AFC tune! beat that :P

Heya guys,

Well doen Rob at the Horsepower Shootout 2002.

I beleive you took out one of the classes to take yourself home a neat little trophie. Thanks for the mention (Brodie not Brody ;-))

And yeah have a look at the write-up here below

http://home.iprimus.com.au/broffbut/perthhps.htm

Also if you go to the models section you can see the girls, the official All 4 Wheels Promotional Girls, which seems to be the talk of the whole perth car scene!!

cheers guys, well done rob,

Brodie

Originally posted by Brodsta

Also if you go to the models section you can see the girls, the official All 4 Wheels Promotional Girls, which seems to be the talk of the whole perth car scene!!

hey dude, when ya gonna finish the page with all the details on the girls ?

and also, what's the deal, are they gf's of the member's or somethin ??

haha, the models section is coming along...gradually. I got their profiles done up with some nice pics, im just waiting on a couple of things before i upload them. I was plannign having them up when i made that post, but..grr...long story.

and they are all taken.......by me.

Originally posted by DESTROY

Terminal speed is a better indicator for HP...

Only in the same way as a dyno mate (ie: under controlled conditions and with calibration).

Things like weight and diff ratio can have a very large bearing on terminal speed.

:)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...