Jump to content
SAU Community

Recommended Posts

For starters ill start with the main mods. RS580 turbos (similar n1 spec), PFC, sard 700cc's, bosch 044 intank, 100mm cooler, turbos back exhaust, PFC, AVCR, RB20 80mm afm's.

I recently had my car dyno tuned and it made about 230kw at all 4 at 17psi (weak I know) and they basically just told me it wasnt making power because of the boost controller and how they are useless. They said gtrs with just some pods, exhaust and pfc running 1bar generally make that or more with standard everything else.

I just had it back on the dyno the other week and now im told there is a restriction somewhere, like a boost leak maybe, said it could be a ton of things, including bov's leaking, cat melted down and blocking airflow etc. The engine is fine and has perfect compression and no noises etc

I know the car is definatly down on power because the car doesnt feel much quicker then what it was stock, and for the money ive spent it should be heaps quicker. Week by week it actually feels like its losing power

Just lately its been playing up doing things like;

- hunts on idle occasionally

- wont boost over 0.3bar sometimes, sometimes it will

- and just recently it started surging very slightly at low speeds off boost just accelerating normally, but today I went to take off and it surged badly, tried to accelerate a little it just wasnt going.

Next im getting rid of the bovs for a single greddy type s incase they are leaking, and "high flowing" the cat abit more. If those 2 things dont fix it then im going to have to get my mechanic to start pulling it to bits and double checking everything till we find the problem.

My question is has anyone had any experiences with these symptons and what are the likely things (things to check for first) if I have to start pulling it apart.

Thanks for any advice

Link to comment
https://www.sau.com.au/forums/topic/71444-gtr-running-like-sheeet/
Share on other sites

Sorry to Hi-Jack your thread but THIS SOUNDS LIKE MY CAR. If you work out the problem let me know. :( Mines basically stock and it wouldnt crack a 15 sec 1/4 . It has the same problem as yours. Feels flat, no mid range power but doesnt make any noises or break down through the rev range. Go figure ..

Mine also hunts sometimes and does various wierd things as your describing. Make sure you PM me if you find the cause and ill do likewise ..

Just take the cat off, take it round the block with nothing on.

You may want to fit a boost controller, and see if that helps.even if is doesn't it will help you later when you want to increase power.

make sure no one left a rag in the intercooler, as i have heard of it before and having simillar effects.

PFC, sard 700cc's - hunts on idle occasionally

Tuning, 95% of the time its hard to get rid of hunting on idle with bigger injector's, but its down to tuning. - generally happens on hotter day's.

- and just recently it started surging very slightly at low speeds off boost just accelerating normally, but today I went to take off and it surged badly, tried to accelerate a little it just wasnt going.

Again this sounds like the tuning, simply take off at higher rpm.

I would start with the basic's first, cleaning the AFM's, checking plugs, looking for leak's or blockage's etc.

Maby even post you'r inj map off the FC if its possible... this would help.

Sounds to me like you need to take it to a new tuner - they should be telling you whats wrong and fixing it, not saying 'ummm theres something not right, we dont know what it is tho'

As for power, with your mods (nfi about turbos, but assuming they are like N1's) you should be making close to 300rwkw... i've got stock turbos, exaust, 1bar boost and make 270rwkw...

Sorry to Hi-Jack your thread but THIS SOUNDS LIKE MY CAR. If you work out the problem let me know. :rofl: Mines basically stock and it wouldnt crack a 15 sec 1/4 . It has the same problem as yours. Feels flat, no mid range power but doesnt make any noises or break down through the rev range. Go figure ..

Mine also hunts sometimes and does various wierd things as your describing. Make sure you PM me if you find the cause and ill do likewise ..

Voona have your cam timing checked it is in alot of cases the cause of a low performing GTR that doesn't do anything wrong just has no power and response .

my mate just got his power fc installed andcat back exhaust, adjustable cam gears and is running 186kw@all 4, is this about right? also 15psi.

it depends on the dyno! my gtr dead stock made only 147AWKW (12psi stock) and with the restrictor removed made 169 AWKW (14.5PSI). to me that seemed a bit low although the improvement was substantial and it felt quick on the road. incidently it also ran 12.8 at 106 at this power so it definately was running well! so I guess it depends a lot on the dyno and a before/after comparison is often more accurate.

I'm thinkin boost leak...shove a plastic cup in the hose each air filter is in and rip off one of the boost lines. Us e a compressor to presuurize the whole lot, from turbs to plenum..spray some soapy water around and look and listen for air leaking.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Do they always do it from the AFM? If so... You know what I'm already thinking I reckon...
    • The other problem is that the pan is on an exchange basis, which would be a pain to have to send original sump to Oz for the work to be done. Would ideally need to be able to pay for a locally sourced core. To that end - I'd just fabricate one outright.
    • Not at all, pure street use, touge, even drag strip and you'll be fine   There's a larger version of it too, however would be overkill for your application. If you do plan on using that sump, might as well fit a headdrain/crank case vent to help alleviate crank case pressure. Your mechanic will also notice you cannot re-use the AWD windage trays on the motor too, as it fouls with the AWD -> RWD sump. However given your usage, you'll be fine.
    • @GTSBoy yeah but the MAIN problem is that "you" guys may know that but i/my mechanic did not. I literally spend hours to find differences between Stagea and Skyline engine (even here) and found kinda "nothing" Yeah one guy mentioned that the block is larger/wider but nothing about the oil pan. Of course AWD has different one but "everybody" says...yeah just slap RWD pan... and the parts number for my N/A engine and NEO DET were the same so iam using one from my old engine. And of course being in EU/Czech many of the sites did not even show(i need VPN to be here)... @MBS206NO it is not my channel and not my video. Dont even know the guy. I just post this as a reference cuz i have the same problem. As i said you guys in AU/NZD may know this but here it is kinda a new info cuz IF someone doing this swap they already have oil pan or they make custom one.  @Dose Pipe Sutututu Yeah it is AWD RB25DET NEO Yeah as you mentioned the pick up is in a different place ...but i do not drift or track the car. It is and will be strictly street and just "casual" weekend cruiser. With that "custom" pan as shown in the video...could there be some problems?  For others. Iam sorry if that topic "looks" like i want to show/boost some YT channel or numbers. Iam quite the opposite.  I would rather drive my car thru sewers than get the attention that this car gets here. I do not have any YT channel nor IG/Twitter or TikTok. I just want some info from time to time cuz here...there is none :-) 
    • +2 Mine came with a bonus flat battery. 
×
×
  • Create New...