Jump to content
SAU Community

removing rear speaker grills

YO880

By YO880,
in Car Audio & Electrical

 Share

Recommended Posts

YO880 Mentor

YO880

Posted
Posted

Hi Guys,

hopefully someone can answer this fairly quickly,

i need to replace my rear speakers, and i was wondering how to get the grills off, i am hoping you don't have to remove the whole rear parcel shelf.. how does it remove anyway, assuming the rear seats are already removed, does it just clip on?

thanks guys

Link to comment
https://www.sau.com.au/forums/topic/7188-removing-rear-speaker-grills/
Share on other sites
MRK25T Experienced

MRK25T

Posted
Posted

I've got some pics I took when I took out my parcel shelf in my gtst - same as a gtr?

I got cranky trying to get the parcel shelf out and snaped both ends. There are 2 white clips you can see in the above photo that you need to deal with to remove the shelf.

Be careful on each edge of the parcel shelf (I think you have to push down at the edges to do it properly - I just pulled and ripped it out).

Mark

MRK25T Experienced

MRK25T

Posted
Posted

Hi Y0880,

Since the last photo was useful I edited one of the ones I took of the rear seat with parcel shelf removed . You will notice there is yellow where the teeth Akeenan mentioned are - from memory it looks like a tiny single fin from a surf board. This goes into the parcel shelf where I have circled with yellow - if you look hard you'll notice that the slot on mine has been ripped.

The two red circles are where the two white clip type things are. After removing the back seat I got my fingers under the parcel shelf near the middle and pulled it up which worked... maybe there is a better way?

good luck with it, hope it helps you and other people.

Mark

  • 2 weeks later...
predator Grand Master

predator

Posted
Posted

Can you repost those pix, they've been removed from the server...

Wouldn't mind getting a look as sometime I'll have to remove the same to install some new speakers in..don't want to stuff the parcel shelf and have to build a new one (time/money) :P

YO880 Mentor

YO880

Posted
  • Author
Posted

Well,

Pulled the parcel shelf out finally today, and it was a little different to your pics, basically there where a few metal wire clips holding it at the rear (near the bottom of the glass), two bolts for a child restraint anchor point, and two fins from the plastic cover on the C pillar that went into the rear parcel shelf..

Got most of the shelf off, but couldn't for the life of me get the right corner out.. finally after a bit of tugging it came out, but i managed to rip the thin bit of parcel shelf off at the back behind the breather grills.. so have to work out a good way to stick them back on..

So's life :P

MRK25T Experienced

MRK25T

Posted
Posted

Ok, i'll put those pics back up now.

Those metal clips near at the rear didn't seem to do anything so when putting it back i didnt bother with them. I guess the guys that did the compliance work with the child restraints didn't bother with them either.

You ripped the parcel shelf like I did with those fins :) Its a bastard of a thing especially with this hot weather + the frustration that builds up over something as trivial as this.

Good luck with your parcel shelf predator666, see if you can get the it off without ripping it.

Mark

YO880 Mentor

YO880

Posted
  • Author
Posted

yeah, it doesn't look too bad though, didn't rip the carpet completely off so hopefully when i add some sound deadener it will hold things together..

I know what you mean about frustration.. it isn't as bad as other cars i have worked on (Holdens are probably the worse so far), but hours in cramped confines never helps :)

i will post up some pics when i get it back all together, probably a few days away yet though..

predator Grand Master

predator

Posted
Posted
Good luck with your parcel shelf predator666, see if you can get the it off without ripping it.

hehehe...well i will give it a good try! But I need some rears to fit in first before I get the willpower up to try and take it out... much as it sucks, just going stockie speakers for now through my new face unit 'till i can get some nice ones. Thinking alpine.

MRK25T Experienced

MRK25T

Posted
Posted

I put some pioneer speakers in for the rear. I also had to remove the stock rear speaker mounts and make my own because the speaker screw holes didn't match up to the aftermarket speaker.

You will also have to do something similar to me out of MDF if you want your future alpine or whatever speakers to fit.

Happy New Year.

Mark

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GoHashiriya
      R34 Skyline Sunroof Won't Tilt/Vent

      By GoHashiriya · Posted

      Actually, that's not entirely true. It's also the same motor in the 1st gen Nissan Cube but they're rare as hen's teeth.  
    • Duncan
      Unknown sound similar to BOV on positive boost with partial throttle RB26

      By Duncan · Posted

      Yeah it is always worth testing and balancing actuators out of the box, just set the pressure regulator on a compressor very low (eg 5 psi) and increase it slowly to see when they both move.....unfortunately while you may be able to adjust the length of the actuator rod to minimise any difference, the actual pressure they move from is not adjustable so you need a well matched pair. And yes, the VCAM is probably contributing; the earlier in the rev range they come on boost and the slower the revs build (I think your demo was in 5th), the more you notice it.  Driving at WOT through 1st, 2nd, 3rd etc you will probably never hear it as any shuffling starts and is over super quickly
    • Dose Pipe Sutututu
      Shoota's R33 GT-R RB30/26

      By Dose Pipe Sutututu · Posted

      oh they were with that motor, you need to remove the engine to change the spark plugs (don't have to, but it does make it easier)
    • nouveau_poor
      Unknown sound similar to BOV on positive boost with partial throttle RB26

      By nouveau_poor · Posted

      I certainly fall into the annoyed camp, but glad to hear that if it's happening at low boost then I'm not likely going to blow a turbo and end up with metal shards in my oil. Just feels like it prevents me from really driving it without hesitation and "peak" performance. Wonder if it's the VCAM, it did an impressive job of shifting the torque curve and faster spool, but maybe now it's "too fast" and there's too much air for how open the throttle is.  Based on some other threads, will also do some reading on synchronizing the actuators. They are the default actuators that come on the Garrett's and I would think they would be set the same coming from the factory, but if the turbos don't actually work exactly the same way at the same time as previously mentioned, it would be worth making sure the actuators are actuating together properly
    • GoHashiriya
      R34 Skyline Sunroof Won't Tilt/Vent

      By GoHashiriya · Posted

      I went down this rabbit hole before, ended up sourcing a motor from the UK (I'm in Japan) which also didn't function correctly. With the original motor, I disassembled it and reassembled it and it works somewhat, sometimes. What I could deduce from all my screwing around is that there is calibration of the gears on the inside of the motor and two ramps on the main gear which activate switches that operate the motor and move the sunroof either to retract into the roof or tilt. Where I got stuck was that, it seemed in my case that one or both of the switches that are activated by the ramp on the gear did not always activate and thus the motor did not move, causing it to sometimes not retract or tilt (apologies, I've forgotten which way it didn't work.).  Of course this part is discontinued at Nissan now, it's the same part in the S15 but no other models. I also contacted the manufacturer of the component for schematics - forgot the name, they're based in Gifu - but they declined to share the information due to being bound by an NDA, sadly. Looking through my pictures now, it seems I last had a crack at this in 2022. See, I so kindly wrote "open" and "close" next to the switches. If you figure it out, please do tell me. Those little switches, with the red buttons may need to be replaced.
×
×
  • Create New...