Jump to content
SAU Community

THE (ONLY) DECA results/photos/experiences/reviews/recollections/brags thread


Recommended Posts

  • Replies 199
  • Created
  • Last Reply

Top Posters In This Topic

hey pete, both you and I didn't get any penalties, even though we wiped out a few cones doing them reverse parks into the finishing box

The people doing the timing were being "un-helpfull" as far as putting times down next to the right numbers (taking into account some numbers were missing due to withdrawals)

So there has been some confusion around numbers 36-40. Especially didnt help when the cars in these numbers didnt run in all the events.

The lastest results are as accurate as I can make them. (There was a different one up for about 5 mins)

hey pete, both you and I didn't get any penalties, even though we wiped out a few cones doing them reverse parks into the finishing box

Where motokhana events were run more than twice only the best 2 times were taken.

:D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...