Jump to content
SAU Community

Recommended Posts

Hi BT, looking for a catback for a SII R33 GTS-T Sedan. would like an oval muffler, not cannon, twin tips if poss.

New or used..

Can collect from Melbourne

  • Replies 116
  • Created
  • Last Reply

Top Posters In This Topic

Hi BT,

im also looking for a catback with oval(twin tip) muffler but for a R34 GT-T. Preferably with just the rear muffler, no mid muffler or resonator & with the least amount of bends, i'd like a system with the least amount of flow restriction. Any suggestions?

Please pm me. Cheers.

Hi BT, looking for a catback for a SII R33 GTS-T Sedan. would like an oval muffler, not cannon, twin tips if poss.

New or used..

Can collect from Melbourne

Hi BT, looking for a catback for a SII R33 GTS-T Sedan. would like an oval muffler, not cannon, twin tips if poss.

New or used..

Can collect from Melbourne

**Note: from last 1st July FUJITSUBO has increased the prices

Hows Fujitsubo Legalis R?

00000000000000002624.jpg

New price - $1,145.00 landed new

Hi BT,

im also looking for a catback with oval(twin tip) muffler but for a R34 GT-T. Preferably with just the rear muffler, no mid muffler or resonator & with the least amount of bends, i'd like a system with the least amount of flow restriction. Any suggestions?

Please pm me. Cheers.

Most Japanese brands do not sell the Muffler alone but available in US market.

For japanese brand, TRUST PE Ti-R catback has straight pipe without centre muffler.

This type of catback has less restriction

power%20extreme%20Ti-R_cropped.jpg

how much can u get for a Kakimoto GT1.OZ Racing exhaust system for a BNR32 GTR

product code is N11308 on kakimoto's web site

plz PM me the price and how long does it take u to land it here thank you

PS plz be aware that it's a 90mm pipe size which is different from GTST (80mm)

how much can u get for a Kakimoto GT1.OZ Racing exhaust system for a BNR32 GTR

product code is N11308 on kakimoto's web site

plz PM me the price and how long does it take u to land it here thank you

PS plz be aware that it's a 90mm pipe size which is different from GTST (80mm)

Roughly $1,150.00 landed (90mm) if they haven't recently increased the price

Edited by BT-Revolution
How loud are the blitz nur specs......and whats the legal amount?

can u list the ones that are legal for the r34 GTT

Legal limit in VIC is 90dB

Only Apexi and Fujitsubo provides the noise level.

Apexi> all of models are over 90dB

Fujitsubo> Legalis R type EVO is under 90dB

Any chance of getting a price on a set of front pipes for a 1989 32 gtr?

Apexi GT-SPEC front pipe for BNR32, 33, 34

Twin Pipe> become 1

70mm x 2> 80mm

Price: $655.00 landed (sea)

  • 2 weeks later...

Is the HKS Silent Hi-Power: (Full stainless) for an R34 GTT going to come in at under 95db?

How much for that system shipped to Brisbane?

  • 3 weeks later...
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Well, yes, every CU on the bus is available via the Consult port, but whether the scanner you are using is capable of talking to the TCU, the ABS/TCS modules, etc etc, is what is at question here. Many of them are only for engine codes. So, if you have one of those, you won't know if the ABS is having a bitch.
    • That's now. R chassis Skylines come from a time when the tolerance in the ADRs was a bit more....slack. My car, on 235/35-17, which is damn near the exact same size as the original 205/55-16, is pretty much bang on correct indicated speed across the whole legal range. That's demonstrated with constant speed run over 5km, and GPS speed. It's just the luck of the draw. My particular speedo head has to be the thing that is "calibrated" that way, because everything else (the diff ratio, the gearbox and the speedo drive**) are all same same as most other Skylines. **OK, so the speedo drive is a Navara unit to drive the R32's cable, not the electronic unit than an R33/4 would normally have with teh same gear on it. Otherwise, I applaud your OCD tendencies, and I would do the same if I needed to.
    • Not too sure, I believe the Nissan consult port does everything? Also just filled up the reservoir to full and the light is still on. The float seems to move up and down fine.
    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph on 255/40 17, so again conservative Google says manufacturers need to set the speedo from 4 to 10% slower than actual road speed.....for safety.....and compliance  After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
×
×
  • Create New...