Jump to content
SAU Community

Dads Car Probs. Need Advice :)

Chef_32

By Chef_32,
in General Automotive Discussion

 Share

Recommended Posts

Chef_32 Mentor

Chef_32

Posted
Posted

Hows it going.

NOTE: QUESTIONS BELOW IN BOLD FOR THOSE LAZY PEOPLE

My dad got an old 91 mazda 929 with a DOHC v6. It started running like crap (no pickup, no power, engine shaking) the other day so i diagnosed spark plugs after finding out my dad hadn't changed them in ages.

So i take out the plugs on the drivers side bank and they turn out worn and there was also some residue on the leads. I change them and then move over to the passenger side bank.

I take off the intake pipe, get the leads out and they have a blown, wet, gooi looking substance on them. All three plugs on that side came out with this crap. I changed the plugs with new ones anyhow.

Then i start looking for other signs of this substance to confirm that it is oil and water mixed. i find some in the airbox where the blow by has brought it in. the coolant level was low a few days earlier and this was topped up, as was the oil.

The car runs much better with the new plugs.

SO NOW I'M PRETTY SURE MY DAD HAS A BLOW HEAD GASKET.

WHAT I WANT TO KNOW IS:

1: IS A REBUILD DEFINATELY INVOLVED?

2: CAN JUST THE GASKET BE CHANGED WITHOUT A FULL BUILD?

3: WHAT HAPPENS IF THE CAR IS STILL DRIVEN?

4: IS IT CHEAPER TO DO A TRANSPLANT THAN GET IT FIXED??

any help would be great

Link to comment
https://www.sau.com.au/forums/topic/83127-dads-car-probs-need-advice/
Share on other sites
ossie_21 Grand Master

ossie_21

Posted
Posted

Not really sure about the rest, but my other car was very low on coolant, just after I had changed it, and the car was running hot. It was so bad on the way home from work I had to leave my car on the side of the freeway, came back the next day to find the passenger window smashed. :)

Turned out to be the head gasket (not exactly sure what had happened), but all I did was change one hose that had a slight leak, and put a thing called Seal Up through the radiator system. It cost about $8, and stopped the leaking, and now it runs fine. This is more of a shortcut, as the problem is still there, but it is now just sealed.

Anyway, if the coolant has gone "missing", then that would be the problem. Idon't see a rebuild happening if there has been no other engine damage, and you could just change the gasket or go the sealer. As for the car still being driven, it all depends on how the car actually runs, but something does need to be fixed no matter what. Good luck.

Chef_32 Mentor

Chef_32

Posted
  • Author
Posted

thanks for that. i'll look into this seal up stuff. I'm just converned that the galleries are going to get covered in this oil/water crap, and everything will need to be cleaned. Maybe some sort of engine flush could do it.

will get the car looked at by a pro on monday.

Till then, any other feedback would be of a great help.

ossie_21 Grand Master

ossie_21

Posted
Posted
where did you get this seal up stuff??

I just got it from Repco, any sort of accessory shop like that would have it. Read the label & see what it says. It's 500ml I think, but it's a dull brown colour, it took me a while to find lol.

However, I'm pretty sure mine was just a crack, so just see what the proffessional says, it could be better to wait. If it needs to be driven on Sunday just drive like a grandma & take it easy!!!

foznice Veteran

foznice

Posted
Posted

there is another kind of seal up stuff. It's a solid that you break up and chuck into your radiator.. how it works.. im pretty sure that it sort of dissolves, runs through your engine and then solidifies somehow when it gets to the leak, which seals up the gaps..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      NC MX5

      By Dose Pipe Sutututu · Posted

      The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • joshuaho96
      R33 GTR running -9 with no tune

      By joshuaho96 · Posted

      Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      I would say no, why, because my daughter, who also lives in Goulburn, hasn't recommended us going there Pity, as we miss all the German joints around in Sydney, actually, the restaurants are the only thing I really miss about Sydney, and a special mention to Ishibanboshi at Bondi Junction, their Kara-age Don is heart cloggingly deliciousness (always added a special boiled egg...or 2) 😋 
    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      Does that German restaurant still exist in the old place out the NW end of Goulburn? When I say "out the NW end of"...I am really being vague. It was 1997 when I was last there, and the only point of reference I can recall is that it was on the opposite side of the main drag from the big merino. And when I say "opposite side of the main drag", I don't mean "on the main drag". It was either a couple of streets back from there, or might have even been out in the sticks a bit further. Was an old farm building or mill or somesuch. And when I say "the big merino" I might actually be thinking of a completely different part of town, because I just looked on maps and the big bugger is not where I remembered him to be! The food was good, consisting largely of various German mystery-meat sausage/loaf things and kartofflen.
    • GTSBoy
      R33 GTR running -9 with no tune

      By GTSBoy · Posted

      So while the second sentence is completely correct and the whole point of the conversation, the first sentence bears consideration. If this bloke is just hoping to throw big turbos on and drive it around, because there are no helpful facilities at all in his tropical paradise** then he likely has zero chance of even knowing what the TP is on the last column in the stock maps, let alone know whether the ECU is operating anywhere near it or past it. So the point is very very moot. And, per what I said before, at stock boost on those turbos, you may well be off the end of the map. **I'm just back from Vanuatu, so I know exactly what small Pacific nations can be like wrt paradise without requisite facilities. But it's not even that simple. I put a high flow on my car and had to drive it around without a proper tune because of the lack of opportunity*** to put the bigger AFM and injectors into it to allow it to be tuned. I had to turn the boost down to less than I had before, and back off the boost controller's ramp, because it was exploring parts of the map that it didn't drive in before, and really couldn't access for tuning on the dyno either, and so was pinging. It was still well within the last column, because when I first**** set up the Nistune on the Neo I rescaled all axes of the maps to give some more space to explore. ***Family dyno was broken ****This was 13 years ago, and the TIM thing wasn't a thing then and so TP would definitely grow when pushing past the stock tune's limits.
×
×
  • Create New...