Jump to content
SAU Community

Recommended Posts

  • Replies 520
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Guest DIRTgarage
a little bit of a DEVIL Paul????

and has the other had its Jap engine fitted that the owner was talking about???

The "other" is nearing completion............I will be sharing a private test and tune day very soon with both of these cars............full competition prep too!

Ahh the urge to run 9's

Guest DIRTgarage
are both going to be ay Jamboree???? fingers crossed they are!!!!!

I envy you mate.... would love nothing more than to get the 200 out on a very good track and run 10's with it :cheers::D

Thats a negative on Jambo.....definately not going to be at Jambo

:D:(

Gonna have to get them to pay their cash up and get then to this test and tune then hey :cheers::D

Can anyone confirm what the go is with unregoed cars??? was thinking of bringing out the Mount Vincent Estates GTR but it doesnt have rego..... are we able to race and what needs to be done to get it on the start line???

I know John races the 300 but was thinking he must have a log book for it....

Edited by ido09s
Guest DIRTgarage
Check earlier in this and other threads.  Un-registered vehicles have to be tech-inspected prior to the event.

Adrian

Correct...also, the owner knows what is required, as the ANDRA officials spelled it out to him at last years Drag Combat

Guest DIRTgarage
thats all good then, in the workshop it stays :cheers::( ANDRA wont approve the roll cage apparently which is a shame, would have been great to get it out on the track and have som fun with it :D:)

Yeah....some of the ANDRA rules are archaic....that roll cage would rate amongst the toughest in aust

Edited by DIRTgarage

well ive never been drag racing cause i think its gay!

what can i say i must be camp

ive even rigged up a rexona can under the bonnet to get that 2rismo look at the line

deposit made!

ill be in the black 31 slagging off camp people

NATIONAL AUSTRALIA BANK LIMITED

Amount: 95.00

Description: fatzdragday

Remitter name: fatzdragday

Transfer date: 19/08/05

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...