Jump to content
SAU Community

Recommended Posts

hey all, i gotta mate that reckons their vtec integra 1600cc automatic can go 280kmh... the speedo has been changed and i think the speed limiter 180kmh removed, so what is the top speed it could realistically do? i thought 230kmh might be possible,... anyone know for sure... i have an r32-t and know with the auto that 230 is tops, so the vteg surely cant do 280 in an auto am i right?

cheers all

ian

Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/
Share on other sites

well 280kmh sounds like a pretty tall story to me .my rb 25/30 de N/A conversion with 3.7 gears and .7 ratio 5th . does 14 .7 1/4 mile and best of a genuine 225 kmh at speed trials winding out over 3 miles . so that 280 kmh figure is " they gotta be dreamin !!! "

Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/#findComment-1519532
Share on other sites

I think you'll find the Integras that came in the vtec form, are not 1.6L for a start.

I've driven the DOHC 1.6L in a VTi-R coupe civic, and these hammer. Between a NA skyline, and a VTi-R coupe, its very close. However, these cars are geared for quick acceleration, which means top speed isn't that great.

The Australian delivered Honda's do not have limiters in them. 280 is a bit far fetched, but 230 is believable as i've been at 210 in an Integra Type R, and it still had a lot to go.

Hope this helps mate.

Dayne

Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/#findComment-1519996
Share on other sites

she reckons they did it on a air strip so room wasnt an issue, i just wouldnt beleive that the auto trans and let alone a 1600 would be able to push the car that farr, top gear in an auto would be redlining before it got up to 230 even wouldnt it? and it looked like a stock car pretty much...

Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/#findComment-1521013
Share on other sites

she  reckons they did it on a air strip so room wasnt an issue, i just wouldnt beleive that the auto trans and let alone a 1600 would be able to push the car that farr, top gear in an auto would be redlining before it got up to 230 even wouldnt it? and it looked like a stock car pretty much...

the 1.6L your talkling about is probly the LS integra DA9 teg

they run the same B16a as the Civic VTIR (coupe/hatch)

i am very doubt full it can hit 280km/h

in my old civic with a JDM B16a (more power LSD etc )

the very best i ran was 220km/h and the revs were sitting @ 7K rpm

and that was very scary for a old EG civic

anywayz i recon if it had the road max it'll ut out is probly 230-40 max

but it'll need a really really long long road

Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/#findComment-1521091
Share on other sites

Theoretical top speed for a R32 GTR is about 250km/h. Don't need a rocket scientist to figure out that a RB26DETT has more torque than a B16A engine. I don't care what aerodynamic coefficent a Intergra is it'll never reach 250km/h (unless a tornado is blowing wind in the right direction and plumetting down to earth from orbit, YES, it may reach 280km/h).

Just cause the speedo says, doesn't mean it can do!

Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/#findComment-1534849
Share on other sites

QUOTE(justin911 @ Aug 20 2005, 11:00 PM)

maybe your friends speedo got changed from km to mph and they didnt relise

that would be about 450kmh

that would be about 450kmh

:lol: pwend :lol: 416.666666666666666666667 actually :D

Edited by Pva_Glue
Link to comment
https://www.sau.com.au/forums/topic/83895-vtec-top-speed/#findComment-1538271
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...