Jump to content
SAU Community

"hiscas" Light Comes On, What Is It!!?!?


Recommended Posts

check if there is a leak under the power steering resivoir..(??) the little bottle which has redish liquid inside... also check how much inside, should be neary full.... i dunno about r32s, (because I dont like them) but in my r33 it had a different diff and there was also a power steering fluid bottle in the boot .. if you have one of these (dont think you would) check it too

Link to comment
Share on other sites

The HICAS controlles the power stearing, there is a high speed and low speed mode. If the speed wire is cut it get's stuck in high speed mode. I had the same prob, I soldered a bridge wire from the speedo to the HICAS speed sensor wire.

Link to comment
Share on other sites

The best way to test is to get a multi meter. the HICAS box in the boot (on the drivers side in my car) has a yellow wire with a green trace, if you unplug the conector and put a probe with a extention wire on it, and put the lead round to the drivers seat. Now you need to pull out the speedo, there should be 3 plugs in the back of it. on the middle plug is the other end of the yellow/green wire. Put the other end of the probe there, and put the multimeter on resistance mode. If you get a reading your wire is fine. if not you have to find where the break is.

Link to comment
Share on other sites

i had the same problem... last monday i blocked my stock BOV so i can get my car to flotter.. while drivin it the hicas light came on and my power steering stifended up... now today, i just got my Apexi BOV put on and it happend again, but this time i hav'nt blocked off the return pipe form the stock BOV in to my air intake. what should i block it off wit?? its steel so i cant really cut it...a ny idea's??

Link to comment
Share on other sites

I wouldn't wast too much time with HICAS, a locking bar might be the best solution and just get rid of it.

At high speed,active HICAS can make the car feel pretty nervous.

Link to comment
Share on other sites

I wouldn't wast too much time with HICAS, a locking bar might be the best solution and just get rid of it.

At high speed,active HICAS can make the car feel pretty nervous.

more scary when it dosn't work, and moves under high force, or bumps in the road.

Edited by sav man
Link to comment
Share on other sites

so no 1 realy knows how to fix it?? i noticed in the skyline R32 the power stearing aint that light? could this be my hicas or are they always like this? or could this be because its stuck in hi speed mode?

i had a look and my power stearing fluid was 2 high.. so i dranied some and now it dosnt come on as often! tonight i had a little race with a 180 and just after it the hicas light came on...

i am still to try this speed wire test.. but i dont have the right equipment!

thanks

Link to comment
Share on other sites

  • 3 weeks later...

I am experiencing exactly what you are experiencing Drift Squad except the Hicas subframe has been removed on my R32 GTR i.e. no more Hicas. The ECU has also been reprogrammed/chipped. The hoses were also plumbed back from where the Hicas was removed.

The car has power steering for the first few minutes and then reasonably quickly the steering becomes heavy at which time the Hicas light comes on until the car is turned off. When it is started again the above symptoms are repeated.

Any ideas?

Link to comment
Share on other sites

so no 1 realy knows how to fix it?? i noticed in the skyline R32 the power stearing aint that light? could this be my hicas or are they always like this? or could this be because its stuck in hi speed mode?

i had a look and my power stearing fluid was 2 high.. so i dranied some and now it dosnt come on as often! tonight i had a little race with a 180 and just after it the hicas light came on...

i am still to try this speed wire test.. but i dont have the right equipment!

thanks

HICAS has been covered to death on this forum. A search would have told you everything you need :P

Yes, it can be fixed (assuming the mechanicals and electronics aren't damaged). Usually its one of the following or a combination (in rough order of occurence):

1) Low powersteering fluid.

2) Aftermarket steering wheel with wrong or incorrectly installed BOSS kit.

3) Poor wheel alignment.

4) Speed sensor wire has been cut.

5) Leaking powersteering hoses.

Link to comment
Share on other sites

ah, the BOSS kit BTW is HBK ON-115, not the ON-110

The ON-110 is for the NON-HICAS GTS-ts (and GTS4's I think)

The ON-115 is compatible with HICAS

incorrect

if it comes with the plug its compatible and it does

last night i changed my steering wheel and when i fitted the new 1 its slightly off centre, it caused the light to come on...

easy fix though.

Edited by silver gts-t
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • I must have read 100 DIY's and watched 200 DIY Youtube videos with most people saying just grab a new cover and, well, despite my normal aproach to these things (replace it all!!) I didn't get a cover. I don't know why I didn't, I'd already ordered a bunch of bits from FCP and it would have made perfect sense to put that in the order.  Anyway, I'm not getting OEM as its just crazy money, even from the states its 900 ish delivered. So, I got an OE Elring one, same as they sell at FCP but local so I can get this fixed this week. Our X5 is waiting for a new diff so we find ourselves in a common scenario of having 2 broken BMW's on the driveway! 🤣
    • Big thing is available inputs for sensors and not having to run multiple expander boxes and software packages for different things why motec is up there. The link ecu and an aim pdm32 was a combination I looked at early on so get ecu, dash and pdm in one go. Aim logging software is pretty good and has all the tracks I will ever drive. Having logging setup with tracks already available is a big thing for myself so can click drop down and go. Thing that I keep seeing is the support what's needed and having a package that people in the know are familiar with as learning a new platform is time consuming.    Got a few boxes that arrived with bits while I was away so hopefully will fit a few sensors and make a start on the dump pipe today. Going to be interesting fitting a 3.5 inch exhaust on this and keeping it above the chassis rails. 
    • Negative Ghost Rider, the pattern is full
    • Chasing a R32 GTR dash pad, must be in good condition, no broken tabs, no holes and preferably no bubbles.   Thanks
    • What's the highest HP figure from a 26/30 setup with standard crank?
×
×
  • Create New...