Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

didnt have much choice in the matter of manual or auto anyway - plus my car is in good nick why get a thrashed manual for the sake of having a manual - plus the clutches eeek haha i fried too many 200Sx's anyway haha.

bully thats right haha well in my case it was - ive seen import auto flogged shit out of (which i got my braces from and a few other goodies) in which i dragged and won by so far - see look after ya machine and it will repay u. Mine is in very good nick - i keep getting told!

could so afford manual!! had 25,000! could afford what i bloody well liked!

mmm got a place in bunbury 3 bedrooms as for everyone else BYO matteress haha. Nah its very nicely decked out but parking is at premium - plus bunbury is quite boring - lots of knocked up little girls wandering around.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...