Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Ooooooohh s-13 cabriolet out front. u dont see those often.

I have almost been busted by multinovas twice today. All the positions have changed since i was last working here. So afe zones are no longer safe. Almost had an accident at lunch too.

A bus was infront of the car infront of me and he stops on labouchere rd so the cr in front of me looks like its gonna overtake and then decides not too and just sits there. I go to overtake the both of them and then at the last minute she decides to overtake and dam near sideswipes me, pushing me into oncoming traffic which looked a little worried. Thnaks to the turbo i was out of there pretty quick though, but it could have turned sour pretty easy.

ouch Boosty .... bloody indecisive females eh? :(

i havent seen a multinova in so long *touch wood* apart from on the causeway - which is where they constantly put them - god knows why in peak hour traffic you can barely do 40km/hr let alone speed!!

Yeah i almost had a big bingle about 20 cm apart!!!

just after the tunnel run. (did 3... i love the tunnel)

Some tool wanted to exit and was not on the left lane and did not check his blind spot.

I beeped rapped the skids, went under him dropped a gear florred it caught up and gave hime the finger while my mate screamed profanity... I have road rage issues.

I was thinkin the same thing. Whats the point? even though it does back their claim that its to keep speeds down not raise revenue.

Then coming through a set of lights and there is a car in the right lane which has a red light and the left lane is free but there are parked cars on the other side of the intersection. I can see the light is gonna change so i come over the line just as it changes for the perfect half dash to get in front. So the *****er at the lights guns it off the line just to block me out, forcing me to stop and let him past. What a tool. He was some bling bling looking asian mofo with a PT crusier with flames down the sides.

yeah wonder where people get their licenses ..... really doesnt pay to have a nice car cos other people just couldnt give a phuck.

Milo - im a pretty aggressive driver - expecially for a female.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...