Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

yep you were :)

I take inconsideration a lot of what my mechanic says etc but i dont see it as gospel .... the only way to find out if a product is good for your car is to talk to the people that have had the same set-up with the same type of car as you have :) Otherwise its a lot of money to spend on a product that you may be disappointed with.

:) u should see my office .... i had it printing from wrong tray and it was spittting out 100 plus pages onto the floor of my office .... so now ive just got a pile of papers on floor!

Government paid my temp agency $1,300 to have me here this week (not that i did a lot) its so high because everything over 38 hours for a temp is overtime and i do a 42.5 hour week here :) so ive got 1.5 and double time included :)

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...