Iron Mask On Hr30

[skdn30]

is this all straight foward?

[0HR-30T]

If you get all the bits it is. ie gaurds,bonnet and striker plate,lights,etc

[Adam_RSX]

Guards arent different are they? I put a MR front on my RSX and the guards worked fine with it

[DR JOSH]

Gaurds are the same. I should know I have smashed up enough.

[0HR-30T]

I just assumed they'd be a bit different at the bottom,as the HR30 has a stone tray,and the iron mask has a full length bar. Similar to the ser 1 and ser 3 R31 fronts.The gaurds are slightly diferent on them,but if the '30s are the same.......... meh

[Ghostrider]

DR Iron Mask guards are marginally different, but only where the front spoiler mounts to it in front of the front wheel arch.

If you have access to an Iron Mask front, a template can be made very easily.

IF you can get the necessary bits, it's 99% bolt on bits, but gettin the bits is the near impossibility (and don't ask me for them if you don't have them already)

The bonnet is near impossible, the grille resembles rocking horse manure for it's availability and the headlights near the same.

You can of course get a fibreglass bonnet from Japan for about $2000 or carbon fibre for $3000

I have been trying to source a grille for someone for about 3 months without success, as I'm not prepared to pay exorbitant rates for these parts.

Happy hunting, as your going to need some luck and lots of patience.

Cheers

[discopotato03]

A little while back Just Jap in Kirawee had an incomplete white front cut , could ask them though the owner races one so mabe not cheap . Headligfhts never seem tyo work as well as MR30's .

Cheers A .

[rsx84]

Guards arent different are they?  I put a MR front on my RSX and the guards worked fine with it

<{POST_SNAPBACK}>

the headlights are very different though as i tryed to fit mr lights to mine (after 4months of looking for dr lights) the guards slope down more. theres proof it does work....

Edited October 7, 2005 by rsx84

[Ghostrider]

the headlights are very different though as i tryed to fit mr lights to mine (after 4months of looking for dr lights) the guards slope down more. theres proof it does work....

<{POST_SNAPBACK}>

The guards don't slope or do anything different than on the MR, the lights though are very different. The DR Iron Mask lights have a different angle AND they are longer by about 30mm. Where the lights meet the guard at the side, the angles are identical.

The white front at Just Jap .... forget all about it, that's where BOOF's front came from, off the same wrecked front cut and as of today, they have nothing for sale for DR Iron Mask 30's.

As I said earlier, finding the parts will be a challenge in itself.

Cheers,

Dennis