Jump to content
SAU Community

Recommended Posts

  • Replies 218
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

This is just a suggestion for the event:

Right before we leave or even during pizza; how's about a little introduction for everyone so we can all put a face to the forum name? Beats spending the whole night wondering who half the people are :)

Just a thought~

This is just a suggestion for the event:

Right before we leave or even during pizza; how's about a little introduction for everyone so we can all put a face to the forum name?  Beats spending the whole night wondering who half the people are :)

Just a thought~

agreed!!

and no more aisan table ....

why did u say the same thing twice??Richard....weired.....

eya , really hope u can make it!!

if u cum i wont drive  , i ll ride wif u !!

yeah i dunno? I just stuffed up i think. ok cool we can go in my car then. :)

I'll probably be there.

What time can we expect to get to Palm Beach?

And CB radios needed or not?

Yea bring CB.. dunno about time... as I dont know my way around up there.. someone else should know.

make sure you bring along an extra set of batteries.. those things tend to die out pretty quickly. ive got 2, and i use them both because im too lazy to change batteries while driving :blink:

Wink, we will be leaving Chatswood on time this week, not waiting for slackers that show up late.

I would expect arriving at palm beach anytime between 10 and 11 considering we will be stopping for pizza at Newport




  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...