Jump to content
SAU Community

Recommended Posts

if its shaky den it's wheel balance..

I had the exact same problem, took it in for a wheel balance (obvious solution)

When they jacked it up at the shop i had a look and the dick before me had put spacers in (to push the rims out), which was the cause of my tyre hitting the wheel guard at every little bump, but when i took the spacer off i noticed there was no hub locater. The lack of a hub locater meant that the rim had play between it and the hub. Machined up two of these little bad boys and problem fixed =no shake

This will only be a prob (i think) if you have aftermarket rims and if the guy that had the car before you was a dick, or the dodgey dealer you bought your car from was also a dick (had these problems)

Cheers

Or it could be as simple as a wheel balance -- easier fix too

Link to comment
https://www.sau.com.au/forums/topic/91458-shaky-at-100km/#findComment-1667531
Share on other sites

Wheel alignment will fix how the car travels down the road. If you take your hands off the wheel and the car continues to track straight then the wheels are aligned.

If there are vibrations, then it is probably (with exceptions like mentioned above) going to be wheels out of balance. Most balancing centres can only balance 16-17" rims. I tried to have some 18"s balance and had to have them driven across town to find a big enough balancer. Without casting dispersions upon the guys that did the balance, they may have taken a short cut with your balance if they didn't have the right equipment.

Link to comment
https://www.sau.com.au/forums/topic/91458-shaky-at-100km/#findComment-1671760
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I bought an engine from a friend of a friend many years ago, it was sold to me as a RB25det Neo.    recently I started pulling it apart and noticed that the intake manifold was pretty different from others that I had seen on RB engines so did a bit of research and found that it was a non turbo manifold. So I’m sceptical now that it is a NEO DET and just thinking it’s a NEO DE (it does have a turbo strapped to it currently).    can you identify the engine model from the numbers on the block?
    • Yeah you can. Cable tie the gauge to a windscreen wiper, or run it into the car and hold it with one hand, or have the neighbour's kid run alongside and tell you what it says.
    • I've never understood why this bothers people. Surely you'd be looking at a T3 flanged Garrett style thing, rather than a TD? You're unlikely to push a +T hard enough to need that much fuel. If you're not starting with most of the things you need to do that (ie, the bloody ECU!), you're better off just going Haltech/Link. You wil hate life a lot less. No. Just no. Just turbo it as is.
    • Have you noticed if the squeak changes with temperature or after driving in the rain?
    • Ok I get you. But isn’t the butterfly intake a headache with the +T?  see this is my plan so far but please advise me into the right direction.  Nistune Ecu, 1000cc Bosch injectors, TD05 or TD06 Kinugawa turbo using stock rb25det exhuast manifold, walbro fuel pump unsure of model I think it’s 450/460, spitfire coils and sparks to suit and a R35 MAF sensor and boost sensor.    I was thinking maybe do a cheap eBay plenum $400-500 or try find a stock det neo intake. I think I’d port match it so it’s getting the full capacity but open to advice please.  Thanks 
×
×
  • Create New...