Jump to content
SAU Community

Recommended Posts

My 33 idles like a WRX but is perfectly fine once the revs are up.

It isnt plugs/ coils etc. Ive done a search but with no help.

What could be the problem?

Thanks in advance :)

Edit: It has hapened before but it just disapeared. I recently changed plenums back to a standard one and now its doing it again but with no sign of leaving.

Thanks again

Edited by 33SOM
Link to comment
https://www.sau.com.au/forums/topic/94280-another-idle-thread/
Share on other sites

Forgot to mention Ive got a new Z32 AFM and a power fc :)

Its only hapened since the plenum change. With the old plenum it never used the aac/ air reg etc and idled good. Ive tried disconecting these with no change :)

vacume isnt leaking anywhere?

That is one thing Im thinking it could be. there sounds like air leaking just below the aac but from what I can see there isnt. I used new hoses aswell.

I unpluged a vaccum hose to see if the idle would change and it didnt. Does that mean anything??

Thanks :)

might do.... not 100% sure but, my car had same symptoms with a vucome line off, id just check em all again to make sure. you can always spray some wd40 on any areas that look sus and see if it changes the idol, if it does you have found your leak.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
×
×
  • Create New...