STATUS

Need asap as in yesterday so if anyone is organised and can ship immediately or arrange pick let me know cheers Trent 0419590220 or 0414944146

still got 33 good crank? if so please call me 0419 590220

if you want a launch interface get the gizzmo other wise forget it... its (bee-r) crude and evil if not setup properly. buy the BEE-r if you like to make pointless noise, and break shit.

yeah the later ones are nice, i half finished fitting a combination of GTst brackets and arms (but using the GTR uprights due to improved bolt in alignment) to my 180sx project and have put it on hold to fit up the later setup, sick and tired of uncle mac in s series cars.. we will see if it is worthwhile.. if not ive only wasted a few hours and some mig wire

Race Pace Creatd me.... and a 1000 others.

two years no greasing with regular checks (i would suggest checking after a trip into the sand traps though ) and still going strong with nil play..... these are used in most of japans fastest super lap cars. http://www.nagisa-auto.com/ Far more than just cheap chinese arms, most have rc + bs correction and so forth in built.

i always use my GIZZMO K-Mon to monitor knock as a back up but the EMU shows actual knock if you get any spike at all it is generally knock.

WTF?? it is part and parcel of fitting extra lock spacers...... not dodgy at all. No pont fitting extra lock spacers if it hits the lock stops at factory lock......

$$$$$

it was a life saver, it lasted until last night i noticed a fw drops on the trailer.... motor is out now though

sorted... cheers. bnb westall road.... legend!

non res and around 7khz works well.

^^ yeah but ive never had issues unless its wired wrong. try updating EMU and software from the greddy japan site.

t-piece the yellow into the blue so they both use the same source, fit controller between blue and red.

Go see ben at race pace he has them, if its like his other work it will be impeccable.

this is the best way; if you dont have the outlet from the turbo t-piece the line from the cooler piping, i reccomend not using plenum as a source.

cheers, i did the last one at home but this time i want it sectioned around the swaybar. i will pm him and find out what side of town hes from.

hey i was looking at some killer av car gear before i left autobarn, 2ch av in for bullet cams 12volt and sd card memory. It was about the size of a ciggy pack. i will find some pics. i could not find the exact one but i will keep searching.

Unfortunatley in TAS we cracked our 26 sump....(huge mofo ripple strips) bit of defcon got us through but i need someone with a decent bandsaw and welding skills to sort out a new sump. any leads would be great.... as i need the car running by sat morning for demos at calder park. all i need is diff cut off and welded up ..... piece of piss and the fron lower edge sectioned to clear sway bar.... also a piece of piss.

im getting UPC in melb to do some brackets, give them a ring.

grind them down, common.

yeah ive used them alot, they are quite a bit smaller (61.3mm vs 65.5mm wheels) and not as responsive as the K5... similar top end per psi though (0.82), but the blitz is running a way smaller housing (0.6ish) to match the GT3582r's power which is quite impressive.... hence my intrigue to fit the big housing on the 'built engine' if this one ever expires

Yeah but that is with a .82 on the to4z, the K5 is currentley running .6ish housing... with the .85 i have seen 560rwhp (418rwkw) quite easily with the #11 housing (using #7 atm) @ 1.3bar, i havent played with the big number 13 housing though, it it is very comparable.

well they are chinese made (section/silk road) so i would not want to pay too much more than 350, the midori ones are made in japan and were copied by many like KTS (also taiwan) etc. if your happy with the silk road ones check out driftshop.com.au and ask costa if he has his version in stock... im sure they would be the same thing and as far as cheap arms go his are the better of what is available here. I ve used his stuff a bit when in a bind and it has alsways been better than the other generic stuff.

ive seen cars make that power for years.... and others last only a few months, there are just too many variables to answer it simply. Tune, oil, kms etc all play a part in longevity.