PLYNX

Hey Guys And Gals; Ran a bit of a search but couldnt find much on the above. Just trying to confirm if a Gt3582 will fit on a HKS low mount cast iron manifold on a R33 gtst with a 25/30 combo ? Thanks in advance.

Your in box is full mate ! Got a set in Syd .!

I think I got one ! Got to check the plugs though as it came out of a r34 N/a ! Im in Syd if that helps

Yes mine ! Run a search in this thread and youll see pics of one I did a while ago !

Thats a bugger cause Ive got a bunch of reproduction LM2 center caps that I did for a guy left over. They look similar though. Good luck with your search

Hey still got one I found after a clean up of the garage !

Im after the small visors that sit on top of the side mirrors on a R33 Contact by PM Thanks in advance

Ah Friggin on the frig fram ! I was after a Q45 AFM and out Penrth way too ! ! Too slow ! To slow ! Free bump though !

Got a brand new one bare in the box ! Run a search under my avatar for pics in the for sale section! It was quite a while ago. Still got it. Thanks

Im after a VH45 90mm throttle body off a Q45. Pick up in Sydney prefered. Contact me by PM. Thanks

I looked a couple of times and I cant for the life of me see what they suit ?

Did you have a read of the A-LSD section at the start of this Drivetrain and tramission section ? It will tell you how to start to fix your problem

I did mine a while ago and changed the dimister to the a green/blue colour to match the aircon controler readout and the hazzard in red. It was a bit of a fiddly job to get them in the original rubber slieve bulb holders but it looks great now. I also did the AUTO switch on the drivers side power window switch

still got it

Still got it

Still need one !

Still looking

Seriously dont waste your time cause I did for about a week after buying one and then trying to fit it up. I even tried to drill the recieving hole in the correct place in the B pillar to take the drivers side belt in my spare wrecked car. You also have to cut away the plastic dress panel underneath the mounting bolt to get the mechanism in there. The only ones I have seen that will fit on the passenger side is from the passenger side off the Nissan GTiR. It also has the extended arm your after They are the same Nissan seat belt.

Im after a either the twin accerator cable mounts on a rb25det throttle body or the whole throttle body. I need it to set up my cruise control properly. Contact me by PM Thanks

Ive tried and the drivers side definatly does NOT fit on the passenger side ! If you try the internal mechanism that tilts has a right angle pin and there is no recieving hole in the correct place in the B pillar

Hey Guys And Gals; Im after the R33 Nismo rear gard flares/ Extensions shown in the pic below. Let me know what you have and contact via PM Thanks

Up to the top

Bump

I have a BRAND NEW RB25DET exhaust cam gear that i m not using. Only opened the box to check it out $65 pick up or can post at buyers expense. Contact by PM.

1 SOLD ! And one to go !