Jump to content
SAU Community

Recommended Posts

hey guys thinking of putting a 25 box in the ceff

ok i know i will need a 25 box + tailshaft, is there anything else i need?

i know i will also need to modify the tailshaft to fit and i have heard a couple of ideas about 'bearbox' crossmember???? can be slightly modified to suit (whatever this is) and SLAVE CYLINDER????? also not bothered about speedo

HELP

Link to comment
https://www.sau.com.au/forums/topic/103164-rb25-box-in-ceff/
Share on other sites

  • Replies 103
  • Created
  • Last Reply

Top Posters In This Topic

Okay once again from the very VERY limited knowledge i have it is all a pretty easy swap but i think the 'yoke' needs to be shortened??????!!!

Good source of knowledge for conversions to Cefiro's is this site

d1nz.org.nz/forum

Since the Kiwi's get the cheaper RB20e auto versions 90% of the time they all are conveting them! :D

My useless 2c ahaha

Ando

no worries

also from my calls today - the 33 yoke is needed and keep the ceffy tailshaft - just needs to be modified

also all the gear selector etc is interchangable from what i've been told

can also use rb20 gearbox crossmember

possibly need the transtunnel 'massaged' a little wider...

Ok I've had it done.

Transtunnel is fine. Dont need to touch it.

Obviously clutch, fly wheel etc all the same.

You will need an R33 clutch slave, I got mine new from nissan for $88.00.

Yes you need the R33 yoke, then you need the cef tailshaft, the idea would be to shorten this. However if your center bearing is stuffed like mine, then you might want to look at getting a 1 peice shaft as this is cheaper than replacing the center bearing apparently (lighter also, so you get back some of that extra weight of the gearbox + less rotating mass)

Rb20 cross member is fine, we just moved mine and put some spacers in. You might need an engineer to look at this to make sure its legal. Mine is actually mod plated.

The speedo... You need your red gear off the R33 speedo sender (the one that goes in the gearbox) this then needs to be attached to a navara speedo drive (32702 - 02G17 pinnion assembly), should be about $22-25 new from nissan, this then connects up to your speedo cable like normal. Just test it tho, should be pretty accurate.

Get some of the seals replaced on the box if they need it. You REALLY dont want oil leaking on to your clutch.

Get your fly wheel/pressure plate/clutch all checked out while the box is out. I had to replace mine that was a cost I didnt allow for.

And why does the gear selector matter? Wouldnt your RB25 box come with one? I dont belive we used my RB20 one.

But yeah, once its done your more afraid your crank is going to snap in your poor little rb20 than your gearbox :)

thats exactly info i needed thanks heaps DD :domokun:

gearbox i'm getting has got yoke etc - clutch was just fitted recently also .

now the hunt is on for a r33 clutch slave

and if its that cheap to get speedo working i'll do that aswell :) - just gotta make sure that red thingo is there

whats it look like? and where?

thanks again - awesome info

Yeah dude, just go down to nissan and get the slave $88 cant go wrong.

OOOH!!!

BIG BIG BIG ONE!!!

You MUST get an S1 gearbox. If you get an S2 your going to have a LOT of stuffing about. The clutches are different (ie one pull ther other push)

AWSOME Article DD... this needs to be stickyed in the parts list of these forums...

shame u didnt type it out when i needed it 4mths ago ;)

Hehe, dude thats prob when mine was getting done :rofl:

hey, im doing the opposit of you guys in a way. im putting a r32 rb20det in to my rb20e powerd r33. i have the electric speedo. what i have been told is that i need the r32 gtst drive gear. what does it look like and where does it go?

cheers

LUCKILY i got an early model box with push type clutch ;)

When fitting the R33 gearbox, what modifications are you guys doing to the propshaft? We are putting an RB25DET engine and box into my cef and where wondering what the deal is?

Is there a propshaft that fits? Or do you need to make one.

Regards

Chris

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
×
×
  • Create New...