Jump to content
SAU Community

Recommended Posts

hey kris..... did poptart get you for power/weght?

out of interest.. what suburb were you in when he got you.. and what car was he driving>?

-mark

his dad was driving the car, so power to weight wouldn't have been an issue

I dont wish to be a smart arse or anything, but from first hand experience pettet does read ns.com and sau forums. They found out all my mods from ns.com, where i had a for sale post. Everything i posted about my car they knew, so I'd say by know he knows you have a chipped ecu, which he'll tell epa, and they'll look for it. May sound far fetched but trust me it's not.

I dont wish to be a smart arse or anything, but from first hand experience pettet does read ns.com and sau forums. They found out all my mods from ns.com, where i had a for sale post. Everything i posted about my car they knew, so I'd say by know he knows you have a chipped ecu, which he'll tell epa, and they'll look for it. May sound far fetched but trust me it's not.

As much as the cops would like you to believe the epa and vicroads dont really give a shit when it comes down to it

Guys to my knowledge the EPA won't care about the hole made for the cooler......the epa stands for environmental protection agency ie they care about what co2 and crap is coming out of your exhaust so they are looking at induction/turbo/ecu basically any mod that changes the fuel/air ratio of your car.

However if you were canaried for the hole it might be a diff story.....

on that note, doesnt aftermarket ECU's allow you to lean your car out, as the factory ECU's are prone to running rich....wouldnt this make them better for the environment, or am i way off and should stop typing right now?

dezz...I had the exact arguement with the EPA years ago. Apparently the ECU manufacturer would have to get an approval from the EPA for each car it can be used on and it would have to demonstrate that it did indeed reduce emissions. As you can imagine that would cost a packet load as each ecu can be used on a variety of cars. Also the fact that they are all tunable would void that approval as the EPA would say that you can change it after it is approved and make it worse for the environment.

Oh and you can get an EPA arroval for your car in its current state (assuming the emission levels fall inside the range)

All you need to do is pay (rough figure) $3000-5000 and even then a cop can force you to do an emissions test to prove that you haven't changed it since then!!

Yeah its about $3000 I just couldn't remember. In other words the ECU manuf. would have to pay $3000 for every car that ecu can be used on. Take the PFC, or wolf they can almost be applied to every vehicle x that by 3k and you understand why they don't do it....

Its just a bastard that it is left up to the car owner but I guess we chose to do the mod :P

The reason a PFC wont pass is because its un-tested on that car, with those mods.

Hence why APS/Unichip pay for testing... which even then you can dodge if you know what your doing.

The emissions are often better, but the simple reason they wont pass if they can be changed as they are a free-tune ECU with no lock.

There are loads of requirements, not just the passing the test

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
    • Hi.. Just another problem. So maybe you can help. I(my mechanic) done swap from my RB20DE NEO to RB25DET NEO. Everything is OK but we have a boost cut. Coils/Plugs are ok...AFM is ok. ECU is ok. I have Walbro 255 but it "changed" sound few months ago(you can hear it ouside) you did not hear that when it was new(maybe faulty?) Sooo...what now? What can cause this boost cut? It is even when you standing still...
×
×
  • Create New...