Jump to content
SAU Community

Recommended Posts

Hey guys i recently traded in my 33gts and topped some money onto that to get myself an 89 r32 gtr ;)

Ive only owned it for a week or so but what are the normal problems that arise with these cars? Im aiming for reliability so any problem areas that i should be careful about? Also, i noticed when i drop gears it sounds like a backfiring system. Its like a pretty loud POP but it only happens sometimes. Can anyone enlighten me? This is my first turbo car btw so sorry in advance for these noob questions =P

Thanks

I would say best option...

1.) full service replacing all oils and fluids (engine, diff, gearbox, power steering, attessa, brakes, radiator, etc..), spark plugs, all filters (oil, fuel, air), timing belt, water pump, and probably other belts.

Clean injectors.

Compression test to make sure it is healthy.

Now that the car is Healthy.... buy and install these.

2.)new fuel pump, power fc, boost controller

3.) tune for safe tune, on our fuel, at something below 1 bar boost.

this should give you a decent power increase, and have a car which is safe and probably last for a long time if treated right.

I'd say the above would cost under $5K

guessing $2K on service and $3K for parts and tune

Popping sounds are usually unburnt fuel combusting on hot exhaust parts. Mine does it very occasionally. Apparently the stock ECUs run rather rich. Nothing to stress over though.

If you are after reliability and have the boost restrictor in, leave it there. As it's an 89 model you should overfill your oil by 1L. And remember not to flog the car until it is warm - most turbo failures occur when guys stomp the gas and the ceramic exhaust wheels are cold and shatter/disintegrate.

This has kept my 1989 RB26 working without a rebuild. And rev210 is spot on dude, adding power to an old motor must be done carefully.

im suprised noone has mentioned the oil pump. it is major, but it happens alot and is a top cause for rebuilds on these things.

ive seen more oil pumps on r32 gtr's go than tyres do on a commo at summernats.

best way to improve reliability is to sell it and buy something new with warrenty, that way you dont have to drive it everyday and hope it dont break down on you and cost you 6000 to rebuild. just my thoughts

best way to improve reliability is to sell it and buy something new with warrenty, that way you dont have to drive it everyday and hope it dont break down on you and cost you 6000 to rebuild. just my thoughts

sorry but i cant afford a newer car than this with around this sort of stock power T_T

im having hell at the moment just after buying it heh

thanks for all the replies guys but just wondering how much would it cost to replace the oil pumps?

my theory is that if its cheaper than changing the engine if the faulty oil pumps cause a major engine failure then its worth changing =P

Edited by nauzilus
sorry but i cant afford a newer car than this with around this sort of stock power T_T

im having hell at the moment just after buying it heh

thanks for all the replies guys but just wondering how much would it cost to replace the oil pumps?

my theory is that if its cheaper than changing the engine if the faulty oil pumps cause a major engine failure then its worth changing =P

Its not. Fixing the oil pump problem requires removal of the engine from the car, and removal of the crankshaft from the engine to press a collar on to the end of the crankshaft (which drives the oil pump). Engine R&R is ~$2000-$2500 depending who you use, and the crank collar work would come to about $1000 or a little bit more.

Other option is to chuck an R33/R34 GTR engine into the car which have this problem fixed.

If the oil pump fails while you are driving, you can expect to be up for a full rebuild. Unfortunately theres no way of telling how bad the problem is until you remove the engine from the car and take the oil pump off. It comes down to luck basically.

you dont need to remove the engine to change the oil pump.

you just need to take your radiator/condensor/fmic/front bar off as they tend to need a hydraulic puller to get their balancers off.

after thats off its a matter of removing your timing belt gear, dropping your sump, replacing the oil pump and putting it back together.

it would take a few hrs at the most to get it all done with the right tools.

it took me just over an hour to get my oil pump off (i dont have a front bar on my car), and that included taking my radiator and condensor out and dropping the sump.

As Duncan said, its basically an engine out job to change the pump on the GTR. Changing the pump doesnt fix the problem though, at the end of the day youre still going to have a short nose drive on the crank. The only real way to fix it is to pull the crank from the engine, grind the nose of the crank, press a new collar on and grub screw it in for good measure.

Pro Engines do this for a really good price, and use a JUN copy crank collar. Is basically identical to the JUN one, but a few hundred $$ cheaper. www.proengines.com.au

Justjap:

Have a look around JDM JustJap, SSS etc....

http://justjap.com/engines.htm

Omori Built RB26DETT -$9800

New GTR N1 Block -$3450

New GTR N1 Engine -$12500

GTR RB26DETT [used] -FROM $6500

i'd like to have that Omori Built RB26DETT -$9800

R34 N1 Turbos, Full Loom

With Harness & ECU

But befor it goes in get it looked over and make sure it's got stuff n1 water/oil pumps etc

what does omori built mean?

damn a brand new engine.. ;)

might be able to afford it after a yr of working part time at maccas.. lol

on top of the cost of the engine i should put aside how much roughly to get it fitted in?

what does omori built mean?

damn a brand new engine.. :)

might be able to afford it after a yr of working part time at maccas.. lol

on top of the cost of the engine i should put aside how much roughly to get it fitted in?

sorry dud i dont mean to offend you in any way, but after asking so many questions it seems to me like your not the kind of person that can maintain a gtr, its not as easy as everyone thinks, and working at maccas is a big no no if you wanna drive your gtr weekends esspecialy when things start going wrong. better sell it for what ever you can get for it and buy something more in your budget, maybe turbo excel or civic or anything else

sorry dud i dont mean to offend you in any way, but after asking so many questions it seems to me like your not the kind of person that can maintain a gtr, its not as easy as everyone thinks, and working at maccas is a big no no if you wanna drive your gtr weekends esspecialy when things start going wrong. better sell it for what ever you can get for it and buy something more in your budget, maybe turbo excel or civic or anything else

ouch.. :P

everyone has to start somewhere man.. gimme a break. =.=

im sure not everyone has a cushy office job like maybe u do but ill do what i can

btw if i dont ask u guys here who are pros at skylines where else can i learn about this? :)

what does omori built mean?

damn a brand new engine.. :)

might be able to afford it after a yr of working part time at maccas.. lol

on top of the cost of the engine i should put aside how much roughly to get it fitted in?

Omori is a tunning house back in the land of the rising sun... :P

Serriously- wait till your over 25 before you buy one of these things-

better/stable job

lower insurance

other intrests

for now just get some thing NA, cheep to run and insure: excell, mirage, lancer with evo kit, civic with vtec badge or kia with bonnet scoop, don’t stretch your self with a loan.

Labour is about $80 hour

I'd think it would be about 10 hours minium to pull out and put in an engine

Then plus another 5 hours for the initial dyno tune and many tunes after that to get it perfect

Just do a search on engine swaps and dyno tunes

Float round the forums for a while and do some back-reading

The answer is here- you just have to find the right posts! or try at Skylines down under...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...