Jump to content
SAU Community

Recommended Posts

0secs when i take off usually, 1-0mins stopping

any cars its a good idea to run up and run down, but still, they're modern cars I am sure they can handle it. Oil can start to solidify in the turbo apparently if you just turn straight off, but i'm not sure how true that is... and whether for daily driving (not a track) that it matters who knows.

Anybody regularly pull turbos off skylines regularly? Do you regularly find bad oil deposits?

sometimes i let mine idle for a bit and sometimes i dont. when i dont i always drive it soft. however if im running late to work or something i'll run outside and start it up and come back about 7 minutes later then i can drive it harder sooner and get to work on time.

I usually drive off (reverse out of driveway) within about 10 secs of (cold) starting the engine, but never pull more than about 3000 rpm, and never pull boost, until the engine is up to full operating temp.

personally i do what most do, start, wait a min or two then drive off and stay off boost till water temps get +60degrees celcius

i read in a recent Merc users guide for a car that i dont remeber, and it said

"dont let the car idle to warm it up in the one spot...start the engine, let idle for a min, then drive but keeping the rpm's low. this is a more effective method of warming up all engine components"

or something along those lines

In the morning I'll start my car, put the turbo timer on 5 mins, then lock and arm the car (car alarm detects TT). I never usually let it warm up for less than 5 mins, but about 2 mins cold start is ok. If the car was driven within a few hours, about a minute does it for me.

As for cooling down, i leave it for 1 min, or if I have REALLY been caning it, about 2 mins.

I dont give it any stick either until temp is half way, and oil preasure is down to 2bar on idle.

This was the approach I took on my R31, and after 7 years (and i used to cane the crap out of it when it was warm), I never once got anything repaired (except fan clutch), and compression was almost the same as it was when i bought it. Hardly ANY noticable power loss.

What i do may be overkill, but if you really take care of your car, chances are it will be a lot lighter on your wallet!

my 2c

  Quote
Originally posted by whistla

personally i do what most do, start, wait a min or two then drive off and stay off boost till water temps get +60degrees celcius

i read in a recent Merc users guide for a car that i dont remeber, and it said  

"dont let the car idle to warm it up in the one spot...start the engine, let idle for a min, then drive but keeping the rpm's low.  this is a more effective method of warming up all engine components"  

or something along those lines

do you drive a merc? :alien:

  Quote
Originally posted by whistla

i read in a recent Merc users guide for a car that i dont remeber, and it said  

"dont let the car idle to warm it up in the one spot...start the engine, let idle for a min, then drive but keeping the rpm's low.  this is a more effective method of warming up all engine components"  

or something along those lines

Thats b/c some people assume that if you warm it up for 10 -15 mins at home in the garage, its ok to thrash it afterwards.... you also need to consider the gearbox, the diff etc. I agree 1 or 2 mins is sufficient, but then you still gotta take it easy...

I got a mate who couldn't give a rats arse for his R31, in the morning he starts the car with the clutch in, and ready in first gear. As soon as it has cranked over, he floors it and lets one rip down his street to warm it up. I keep telling him off, but he seriously couldn't care less for his car...

He also does this b/c his choke is wrecked, so this prevents his car from stalling at the first set of lights...

I normally kick it over as soon as I get in the car, then let it idle while I get myself ready - normally between 30 and 60 seconds. Then not go over 3K RPM until the engine is nice and toasty. Depending on how I drive it, I may turn it straight off (like a trip up the road to the shops) or leave it running for up to 7 minutes (long trip on the open road draging off everything I come across). Normally I leave it for about 3 minutes after an average drive. Listen to some music, check the mailbox, clean off the mats, or just admire my toy :-)

Guest nismogtsx

Same as the rest.... Let it idle for a minute while i get my glasses out and light up a smoke... then im ready... But i find the car produces more power prior top the TT reading an air/fuel ratio...

This week end im gonna d/c the O2 sensor from the ECU and see what happens.... Should go hard but i believe it will chew fuel...

Might be a good drag racing technique....

Will post the results...

yeah-i read in a bmw manual that the most efficient way to warm up the car was just to drive off, going easy on the accelrator for about 5 mins-seems easy enough to me, and better than sitting round waiting for a car to warm up... so yeah, just stay off boost (if u can help it) for like five mins

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
×
×
  • Create New...