Jump to content
SAU Community

Recommended Posts

without listing the full car specs

its impossible to tell

it might be cheaper for a 2530.

depends on every mod that you have not listed

hey r31nismoid, say with the basic mods:

- boost controller

- 3" dump/front

- 3" hi flow cat

- 3" catback

- fmic

- safc

- fuel pump

what would you prefer from either turbos that would produce more power, hi flow or 2530?

what would pull better 1/4 mile times?

Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2114754
Share on other sites

the 2530 will peak and drop off more im pretty sure. the rb25 turbo upgrade thread has plently of hiflow and 2530 graphs to look at and compare against. the 2530 is probably cheaper but the hiflow will perform better i expect

Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2114995
Share on other sites

just for some information

i just bought a hiflow for 800

it did have a bit of play in it, and it is plain bearing turbo.

it cost me around 200 bucks for the rebalance, and 270 thrust bearing.

not sure what size wheels are in the turbo, but on my stock turbo i ran 12 psi and had 201rwkw.

with the hiflow i notice a significant difference in power, and spool time.

and when it winds up now, it sounds like a truck.

i ran a 14.089 with the stock turbo, but it was only my 4th time out there

and i didnt get my starts as good as i would like

i'm hoping to rund some low 13's next time i get out there and put the boost up to 15psi.

Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2115369
Share on other sites

GCG don't do two stages anymore I don't think. The stage two had compressor surge issues.

SAU NSW members get 10% discount at GCG.

I reckon for an R33 GTST then a 2530 would get down the quarter quicker. Just so much mid range punch.

Aquariz you should get a powerFC with your turbo upgrade if you want to take full advantage of it.

Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2115726
Share on other sites

GCG don't do two stages anymore I don't think. The stage two had compressor surge issues.

SAU NSW members get 10% discount at GCG.

I reckon for an R33 GTST then a 2530 would get down the quarter quicker. Just so much mid range punch.

Aquariz you should get a powerFC with your turbo upgrade if you want to take full advantage of it.

i thought the hi flow turbo is meant to be stronger?

i know 2530 kicks in quicker then hi flow because hi flow kicks in the same as stock

doesnt it also have a big mid range punch similar to the 2530?

does anyone have a dynograph of the rb25 stock turbo and a hi flow... would like to compare

yea abo bob i wish i could get a powerfc on my car... just hate the fact that i cant... auto transmission

i was wondering which from the 2 and a gtrs will have higher rwkw by 5000revs? anyone?

Edited by aquariuz6
Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2115834
Share on other sites

Look, it's not the worst turbo in the world and they didn't have surge issues with all of them, just a fair few. It might be ok but it might be the reason the current owner is selling it.

I get full boost of 0.9 bar at 3200rpm but I do notice that it spools very early, just takes a bit to get full boost.

I think 2530 to run 12's is a proven combo. For some reason I don't seem to notice decent times with highflow turbos. I'm running 13.4 atm and I wont bore you with my issues but the weird thing is that I run very good times on the roudy roundy tracks. Maybe I'm just no good at the short one.

But still there it is, I've got 255rwkw with a highflow but I can't get a 12 but it has been proven that 220-240 from a 2530 will get you one.

Watch this space though. I might get there yet with a little practice. Going to a test and tune day soon.

Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2126154
Share on other sites

But still there it is, I've got 255rwkw with a highflow but I can't get a 12 but it has been proven that 220-240 from a 2530 will get you one.

The 2530 Probably provides more average power and at lower revs hence the better times. Got a dyno sheet by any chance?

Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2126821
Share on other sites

  • 2 weeks later...
The 2530 Probably provides more average power and at lower revs hence the better times. Got a dyno sheet by any chance?

---------

My Hks 2535's failing after 75k kms due shaft play setting in and making wailing noise. Have ordered the

gt-rs and hope its a better choice than 2530kai. The gtrs is stronger from 3000rpm and has just slightly less response <3000rpm. From Hks web:

gtrs: graph_01.gif

2530kai: graph_02.gif

Edited by docang
Link to comment
https://www.sau.com.au/forums/topic/114828-performance/#findComment-2165548
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Kinkstah, no, coilovers aren't illegal, especially as a bolt straight in. The illegal part will be if they're altering suspension geometry beyond factory limits, or the ride height is not legal.   Sounds like the blue slipper just didn't want to deal with any later possibility of mods appearing on the car.
    • The problem has always been that coilovers are able to be adjusted, almost at any time, to be too low. Most people who ever get/got defected for/with coilovers were actually afoul of the minimum ride height rule. So the interpretation by cops/inspectors was always that it is pointless to allow numpty to raise his coilovers and get the car inspected/cleared, then just drop them back down again as soon as they get around the corner from the inspection station.  This led to the interpretation that they were illegal unless rendered such that they can't be adjusted (ie, collars welded to the body, that sort of thing). That may or may not have ever actually been the official line, but I'm pretty sure it's not considered to be a solution these days. Coilovers themselves fall under clause 3.2 b of that manual, because they are an "installation of a variable ride height system" and they don't fit the exclusions in that clause (which point to air springs and other pneumatic adjusters). So, as per previous statements, they require engineering cert to be legal on the road. Once you have such cert, provided you do not adjust them outside the height range covered by the cert, you are OK. Without, you have an unroadworthy vehicle.
    • Here E10 is the cheapest fuel. And general advice is to not use it unless you hate your car. From what I remember it clogs up stuff in the fuel system or injectors?  With US/Canada being E10 across the board, does that mean that all fuel there is terrible?
    • Sorry, are coilovers ACTUALLY ILLEGAL in NSW? They aren't in Vic, as long as they retain 70% of stock travel and the car is above 100mm off the ground. Does NSW actually have a law making coilovers actually illegal? RWC/Blue Slip/Engineering people not knowing the actual f**king laws boils my blood. Demand them to point to the documentation that states a coilover is illegal. (it may exist in NSW ) Edit: I checked. They aren't. https://www.nsw.gov.au/sites/default/files/2021-02/RMS-infosheet-light-vehicle-modifications-manual-suspension-and-ride-height.pdf
×
×
  • Create New...