Jump to content
SAU Community

Recommended Posts

hey ppl i got a 93 gtst manual which consits of

-Front mount

-pod filter

-full 3 inch exhaust with split dump/front from batmbl

-greddy boost controller set to 11 psi

the results were 181.1HP

max hp came in at about 5100 rpm however my boost seemed to drop back to stock psi as the revs got higher any idea ? the guys at hyperdrive said the ebc might not hav been set up properly il try ge ta pic of the dyno sheet asap

cheers sam

Edited by Sammie
Link to comment
https://www.sau.com.au/forums/topic/115128-had-my-car-dynoed-today/
Share on other sites

  • Replies 104
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

i think they came with the RB20DE and RB20E, not the RB20DET though. I would say its a RB25DET. 181rwhp @ Hyperdrive seems a little low, im gonna go there in a few weeks to get mine tuned. I have same mods with SAFC II and no boost controller. will compare it to that once done.

yea its a rb25 guys the bloke there said i should be looking at getting a power fc just was dissapointed hearing ppl with the same amount of mods reaching 200 + was kinda hoping for atelast 200

sorry but thats a bit ambitious...

the boost is probably too high for the stock computer for a start...that wont help...other than that you've got an exhaust and a pod....

justin911 for example is just making 200rwkw and has full 3 inch zorst, fmic, 12psi and power fc...

you may have read rong it perolly sed 181.1kws???

I seem to agree with Supadan.

While power figures do vary from car to car and dyno to dyno, it does seem like a fairly low power output for the mods you have listed.

Assuming that everything is running properly, and AFR's are good i'd be expecting higher myself. 180kw's sounds realistic. 180 hp seems low.

But like I said, the low power could be due to any number of things.

Dyno readings aren't gospel.

Edited by insu

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...