Jump to content
SAU Community

Recommended Posts

  • Replies 403
  • Created
  • Last Reply

Top Posters In This Topic

I thought i'd take some pics with the GTR caps on the wheels, and at a nice park.

Here's a few to look at, the whole bunch can be downloaded from here if you guys like (28.2MB warning)

http://www.allblitz.com.au/sau/r34gtrwheels.zip

Give me feedback guys !!!!!

post-14128-1155366939.jpg

post-14128-1155367006.jpg

post-14128-1155367074.jpg

post-14128-1155367146.jpg

post-14128-1155367208.jpg

It's sweet as man... HOT! Was going to purchase a set of them for myself... but settled for their younger brother. Looks great man, just thinking though, how much clearence you'll have with coilovers? You planning on rolling the guards or are they already done?

Coilovers are already on the car with those pics taken. I'm only going to lower it slightly if i do that is. I think the height is fine as is. Any lower might make the ride uncomfortable, considering its my wifes car and we have 2 kids :thumbsup:

Coilovers are already on the car with those pics taken. I'm only going to lower it slightly if i do that is. I think the height is fine as is. Any lower might make the ride uncomfortable, considering its my wifes car and we have 2 kids :thumbsup:

Fully, fair enough, and yeah... looks great as is. :dry:

I am a Private Investigator and i use my R33 4Dr for surveillance.

Great car!

So rare they are simply overlooked.

Its perfect, the turbo engine gets up when i heed it and is more than adequate for long hours sitting in the back seat!!

Totally underated.

My OTHER car tho..........well, thats different!!!

Don't you remember this car allblitz?, ibrought it off you. Has been lowered with King springs (30mm), kit from Carmate is the same as your white 34. Thought about Uras kit which i like but a bit expensive $1300 plus paint and fit prob $1000. Think it looks better on white sedans too.

post-26384-1155983862.jpg

post-26828-1155986227.jpgpost-26828-1155986306.jpgpost-26828-1155986080.jpgHey thought I may as well throw me two sedans in there, silver one has;

4.11 geared Mechanical LSD

RB25 Bored 40 Thou with forged internals etc

Wolf 3d V4 plus

PWR FMIC

Bosch 044 fuel pump

GTR dash

Electronic boost controller

Modded Plenum

Turbosmart Plumb back BOV

Bilstein suspension

Apexi Exhaust 3.5", turbo back

3" high flow cat

HEAPS MORE to get 220kw@wheels

(CAR CURRENTLY DISMANTLED FOR PAINTING, SOON TO GET OS GIKEN TWIN PLATE CLUTCH, LARGER TURBO, and 500cc Injectors

Wifes car Dark grey is pretty much stock with HKS exhaust only

Here's my 34, waiting on bodykit from carmate, taking ages. Rflirty4, am also in Kilsyth, is your coupe a white S1?

GTX-R34 no not my S1 white coupe. If your refering to the R33 on Mt Dandy road near primary school I have also seen this one here a few times. We do live just up the road in the estate from that one though. Hubby has got Silver R33 GTST S2 coupe. I am waiting for a Silver R34 GTT S2 4 door, and no doubt when I have the R34 in my drive way it will be out and about quite a bit. I cant recall seeing a R34 4 door around here, I will look out for you, nice GTX too by the way, you will have to post pics when you get your kit so I can see what it looks like! :laugh:

Unique looking R33 you had. I cant recall having seen it though. Yes the front bar on the S2 is a bit different hey. Not the best for fitting a front mount intercooler, bit restrictive. Maybe after I get a few other bits and peices done first (lowered, intercooler, air filter etc) then I can look at getting another front bar. Your in the market for a new body kit for your GTX too arent you. Keep me informed so I can see what it looks like!! The standard boot spoiler is sleek and neat, I agree! I cant wait till I get it! Will be out and about crusing when I do, if I can afford the petrol?? :rofl:

post-30798-1156047594.jpgpost-30798-1156047490.jpg

My 33 sedan...which i just sold, hopefully getting 34 4door

First thing i have to say those wheels are mad..

And i know its a little rude but how much were you asking for it ?

And what did you get ffor it?

And what mods ?

post-24801-1156256547.jpg

First thing i have to say those wheels are mad..

And i know its a little rude but how much were you asking for it ?

And what did you get ffor it?

And what mods ?

http://www.skylinesaustralia.com/forums/in...howtopic=115408

here is the sale thread for it :O

hot ride!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
    • So, what else.... Power. I don't know what it is making because I haven't done a post tune dyno run yet; I will when I get a chance. It was 240rwkw dead stock. Conclusion from the day....it does not need a single kw more until I sort some other stuff. It comes on so hard that I could hear the twin N1 turbos on the R32 crying, and I just can't use what it has around a tight track with the current setup. Brakes. They are perfect. Hit them hard all day and they never felt like having an issue; you can see in the video we were making ground on much lighter cars on better tyres under brakes. They are standard (red sport) calipers, standard size discs in DBA5000 2 piece, Winmax pads and Motul RBF600 fluid, all from Matty at Racebrakes Sydney. Keeping in mind the car is more powerful than my R32 and weighs 1780, he clearly knows his shit. Suspension. This is one of the first areas I need to change. It has electronically controlled dampers from factory, but everything is just way too soft for track work even on the hardest setting (it is nice when hustling on country roads though). In particular it rolls into oversteer mid corner and pitches too much under hard braking so it becomes unstable eg in the turn 1 kink I need to brake early, turn through the kink then brake again so I don't pirouette like an AE86. I need to get some decent shocks with matched springs and sway bars ASAP, even if it is just a v1 setup until I work out a proper race/rally setup later. Tyres. I am running Yoko A052 in 235/45/18 all round, because that was what I could get in approximately the right height on wheels I had in the shed (Rays/Nismo 18x8 off the old Leaf actually!). As track tyres they are pretty poor; I note GTSBoy recently posted a porker comparo video including them where they were about the same as AD09.....that is nothing like a top line track tyre. I'll start getting that sorted but realistically I should get proper sized wheels first (likely 9.5 +38 front and 11 +55 at the rear, so a custom order, and I can't rotate them like the R32), then work out what the best tyre option is. BTW on that, Targa Tas had gone to road tyres instead of semi slicks now so that is a whole other world of choices to sort. Diff. This is the other thing that urgently needs to be addressed. It left massive 1s out of the fish hook all day, even when I was trying not too (you can also hear it reving on the video, and see the RPM rising too fast compared to speed in the data). It has an open diff that Infiniti optimistically called a B-LSD for "Brake Limited Slip Diff". It does good straight line standing start 11s but it is woeful on the track. Nismo seem to make a 2 way for it.
×
×
  • Create New...