Jump to content
SAU Community

My Car Is Broken :(

mitchy_

By mitchy_,
in WA Wasteland

 Share

Recommended Posts

mitchy_ Grand Master

mitchy_

Posted
Posted

so i was just leaving my house this morning, and as i got half way down my street, the rear right hand stud sheered off, and as a result the rim ended upin some guys garden.

due to a lack of a rim, the car slid along the road for a bit, into a kerb, and smashed the front bar :no:

all the underbody is shreaded, the side skirts are all cracked and torn, and the suspension parts on the rear right are basically screwed.

scared the shit out of me, lucky i was only going slow, else it could have been really bad

ive got somepicson my camera, im uploading them as we speak.

if anyone knows a good repairer for these types of problems, let me know!

thanks.

Link to comment
https://www.sau.com.au/forums/topic/118940-my-car-is-broken/
Share on other sites
mitchy_ Grand Master

mitchy_

Posted
  • Author
Posted

guess i should probably mention it was my r/c car..

however it now lives!

the only part that died was a bug-eye wrx shell, which got replaced with a JGTC R34 GTR shell, and it gained about 15rwhp just from that alone.

:rofl:

HypeR33 Mentor

HypeR33

Posted
Posted
guess i should probably mention it was my r/c car..

however it now lives!

the only part that died was a bug-eye wrx shell, which got replaced with a JGTC R34 GTR shell, and it gained about 15rwhp just from that alone.

:P

hahahahaha :D

 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...