Jump to content
SAU Community

Recommended Posts

nah screw you guys. i aint takin no hooked from ipswitch....cause shane already told me they are bad news...how does he know...i dont know.

neither from the sunnycoast...cause its too far.

Edited by Oblivion

Whats with all the dodgey trading shit of late. Other sports forums i have been involved in go out of their way to root these f**kers out and get recompense. The mods in this joint only seem interested in doin whingy shit when someone has a cry cos their nose got put out of joint. >_<

no, I dont think it is working properly. As it is, it will be feeding oil to the middle gallery on the adaptor plate / block which simply cant be right - also cranking the engine hard for quite some time gets no oil preassure and the oil light stays on, then again its a bit low on oil now as I lost some in the process and have to top it up.

Ill prime all the oil lines by pouring the oil into the filter plate until it doesnt flow anymore then fill the engine up, then crank the engine and see what happens.

nah screw you guys. i aint takin no hooked from ipswitch....cause shane already told me they are bad news...how does he know...i dont know.

neither from the sunnycoast...cause its too far.

I'll pay for the maxi taxi up to the sunny coast, and we'll all put in for the hooker.

I'll prove your a premy

see now if you learnt to drive you wouldnt need slicks... >_<

What times were you pulling on street tyres again shane... Oh whats that, nothing, oh you cant cause your car is broken.

Oh thats right :sick:

Will we see 11s Col maybe 10s ?

Yep... 11's for sure, maby a 10 if I push it hard enough...

i just realised something...you guys want to see me.....blow my nose.....that is disgusting guys. you pieces of gheyness

Where did we mention we were going to watch. we will interview you and the hooker. hear both sides, study what was said, body language ect. Then we will know.

What times were you pulling on street tyres again shane... Oh whats that, nothing, oh you cant cause your car is broken.

Oh thats right >_<

Yep... 11's for sure, maby a 10 if I push it hard enough...

13.5 @ 107 in my 191rwkw gtst, with a 1.8s 60 footer, want me to show you the timeslip?

and whats ur best so far col? :sick:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
×
×
  • Create New...