Jump to content
SAU Community

Recommended Posts

God-dammit.

Justin wins again.

He has also volunteered to find the cars for the next mystery car bit in the newsletter!

But - I have a second place prize here for someone else to try and guess the cars.

Well done, smartass Crispy :)

Hehe, yeah I wasn't sure who was in charge of the comp this time...

He has also volunteered to find the cars for the next mystery car bit in the newsletter!

I don't remember that, but very well, I shall attempt to use my powers for good, not evil :P

God-dammit.

Justin wins again.

He has also volunteered to find the cars for the next mystery car bit in the newsletter!

But - I have a second place prize here for someone else to try and guess the cars.

Well done, smartass Crispy >_<

PM sent.

They were pretty easy. It might be a bit harder if they werent all italian.

Its a shame sau is blocked at work or i could waste my days on pointless crap like this.

PS. Let me know if your not happy with the name of the Alfa. Just found out it had a couple of names and wasnt just a prototype.

Nice work Tommy :sick:

You win 2nd place!

And yeah, these weren't as hard as last time. I was on an Italian theme.

Next issue - expect something much harder (and that's without Crispy influence - I have a new idea)

>_<

For those of you playing at home, we have:

1. Fiat Dino Spyder

53.jpg

2. Lancia Beta Montecarlo

lancia_monte_carlo.jpg

3. Alfa Romeo SZ Zagato

T_398.jpg

4. Lamborghini Espada

Lamborghini_Espada_1968_02.jpg

Note different pix just to prove their existence as real cars :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...