Jump to content
SAU Community

Recommended Posts

Ok very easy, disconnect you battery negative will do

and leave the door open so that the light is on and once you

take the neg. off the batt go and pump the brake

a fewtimes or just try to turn sumstuff on like centrallocking etc

just to drain allthepower from the caps in theecu and in the car and

then give it a fewminutes and simply re-connect and start car, go for a drive and alldone. :-)

Ok I just so don't believe in that method

1* Remove fuse panel on driver side

2* Locate the plug like in the picture below

3* Find a paper clip, Turn on the reds (don't start) Short circuit the 2 wires for 2 seconds. (WIRE COLOURED BLUE/BROWN)

Your ECU is now reset and in diagnostic mode. If you get 5 fast flash's and 5 slow flash's with your engine light all you sensors are fine. If not refer to the code list below. AND YOUR DONE !... With no stupid battery terminal removal.

Cheers,

Alex...

Ok very easy, disconnect you battery negative will do

and leave the door open so that the light is on and once you

take the neg. off the batt go and pump the brake

a fewtimes or just try to turn sumstuff on like centrallocking etc

just to drain allthepower from the caps in theecu and in the car and

then give it a fewminutes and simply re-connect and start car, go for a drive and alldone. :-)

  • Like 1
i want to reset my stock ecu in my Series II r33 Gts-t so it learns that i have changed my dump pipe / front pipe / & cat back .. and upgraded smic ..

how do i do it and what is the procedure step by step?

plz help .. much appreciation

Nissans have no LTFT (long term fuel trim) capability, they are a dynamic system so only STFT (short term fuel trims) are learnt which means every time you power off it loses any of the changes it may have learnt. So in doing a reset it will do sweet f**k all in terms of fuel metering and most likely do nothing at all with ignition - but feel free to reset maybe it will fix you big end knock!!!

  • 4 months later...
Nissans have no LTFT (long term fuel trim) capability, they are a dynamic system so only STFT (short term fuel trims) are learnt which means every time you power off it loses any of the changes it may have learnt. So in doing a reset it will do sweet f**k all in terms of fuel metering and most likely do nothing at all with ignition - but feel free to reset maybe it will fix you big end knock!!!

Ok now im confused, does anyone have proof or anything saying that disconnecting the battery or shorting out the fuse thing actually reset the ecu?

i know its a long thread that people have been reading but does any of these actually work?

I aint no mechanic but yeah im sure more then just me would like to know.

Cheers M

Ok now im confused, does anyone have proof or anything saying that disconnecting the battery or shorting out the fuse thing actually reset the ecu?

The ecu contains form of memory that retains its state after the power is removed. No flash, no eeprom. There is no possible way it can store fuel trim maps between drives without constant power, which I'm quite sure that it doesn't because power is removed when the car is switched off.

I'd be looking elsewhere for your problem if you have one

There is no possible way it can store fuel trim maps between drives without constant power, which I'm quite sure that it doesn't because power is removed when the car is switched off.

Nissan ecu's do have a constant power feed direct from the battery.

I think people are grossly overestimating the capabilities of the ecu's self learning.

The ecu contains form of memory that retains its state after the power is removed. No flash, no eeprom. There is no possible way it can store fuel trim maps between drives without constant power, which I'm quite sure that it doesn't because power is removed when the car is switched off.

I'd be looking elsewhere for your problem if you have one

power still flows even after you switch off the car, that is why if you leave your car battry in without switching on the car for a month or so the battery will be drained

although how does resetting the ecu makes it re-learn? I think the ecu will retain its memory, just like your computer, you switch it off, pull the plugs, you don't find all your data lost..

if the ECU has self learning and STFT, wouldn't fitting the exhaust system automatically be recognised? so why bother to re-set?

Nissans have no LTFT (long term fuel trim) capability, they are a dynamic system so only STFT (short term fuel trims) are learnt which means every time you power off it loses any of the changes it may have learnt. So in doing a reset it will do sweet f**k all in terms of fuel metering and most likely do nothing at all with ignition - but feel free to reset maybe it will fix you big end knock!!!

^^^

that's what i've been told by a couple of tuners.

apparently, any learning that may occur will basically happen each time you start the car, although it's minimal to none. The ecu just isnt that smart.

  • 5 years later...

Nissans have no LTFT (long term fuel trim) capability, they are a dynamic system so only STFT (short term fuel trims) are learnt which means every time you power off it loses any of the changes it may have learnt. So in doing a reset it will do sweet f**k all in terms of fuel metering and most likely do nothing at all with ignition - but feel free to reset maybe it will fix you big end knock!!!

I was under that impression too, it is a closed loop system and changes dynamically to achieve stoich. Timing is a fixed map and only retards on knock detection.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...