Jump to content
SAU Community

Recommended Posts

Ok, so I have most of my plumbing back together, all bar the small (8mm?) hose that connects next to the bottom radiator hose on the block. Where does this hose connect to in the system?

Also, anyone got English instructions for the D1 breather tank as I lost my instruction sheet (even if it was in japanese)

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/131935-what-is-this-hose/
Share on other sites

It's where the bottom hose fits the block on the rear side of it. I don't have a pic unfortunately. I figure that it goes in a loop to the t/body and into the runners for the plenum (ath the front end of the plenum on the top) Problem is that my new subzero plenum has the water lines blocked off. Will this cause problems if I am making sense?

the hose that is part of the throttle and bleeder system that runs off the back of the thermo housing goes up into the plenum around the injectors, then out the back of the plenum to the turbo ... you must keep this hooked up.

that's what I thought it was. Much appreciated.

I can't get a straight answer from people as to why coolant is required to go through the plenum around the injectors. But this subzero plenum has a plug on one side screwed in and some sealant blocking the back end that goes to the turbo line. So basically, it wasn't flowing coolant on it's last car and does it really need to? Cheers

I can't get a straight answer from people as to why coolant is required to go through the plenum around the injectors.
I imagine it's designed to keep the inlet runners warm, thereby improving and maintaining the vapourisation of the fuel.

I have a baby T3 that has a bigger front wheel.

The water line from that is now tee'd into my heater lines.

The small hose behind the bottom radiator hose (going into block) now connects to my breather tank.

I have been told that it's for cold start only to have the water in those runners and is better to leave dry. Should be set now.

I have been told that it's for cold start only to have the water in those runners and is better to leave dry. Should be set now.

if you could get a better explaination about this statement i would be insterested..

as for cold starts the water is cold, what would cold water do for the injectors on a cold start???

--been looking into running a bleeder tank on my car too.. good to see it works hooking it up here

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...