Jump to content
SAU Community

Recommended Posts

Hey there,

I know that most of you properly know about the new shell fuel called V Power that has now replaced the Optimax fuel that alot of Skyines drivers run in there cars, however a few nights ago speaking to the lady at my local fuel station she told me about V Power Racing, and I had a bit of a chat to her about it.

Now, at this stage V Power Racing isn't at many Shell Servos, only selected ones I belive, I think within a 20-30KM radis from where I live there is only two servos that have the new V Power Racing.

It is susspose to be more fuel efficent, cleans your pistons etc.

Here's what shell say in there little book:

Shell Unleaded: Regular fuel containing a fuel economy formula designed to take you furthur.

Shell Unleded 95: Quality fuel that features an octane rating of 95 which is perfect for drivers of many new cars, especialy new European and Japanese cars.

Shell V Power: 98 octane premium performance fuel that can keep a new car performing like new for longer and in some cases can help rejuvenate older cars.

Shell V Power Racing: Australias only 100 octane fuel with 5% ethanol designed to allow many modern and high performance cars to perform at their peak.

Would running V Power Racing in Skylines weather they be GTS, GTST, GTR, GTT be good for the car and better on performance? Has anyone use V Power Racing? If so, what are your comments on it?

I haven't used V Power Racing, but I am using V Power it seems the same as the old Optimax to be honest, although the fuel has been designed byFerrari.

Link to comment
https://www.sau.com.au/forums/topic/140171-v-power-vs-v-power-racing/
Share on other sites

V Power = Optimax

V Power Racing = Optimax Extreme

I believe V Power Racing is only beneficial if you have your car tuned to take advantage of the ethanol factor.

Thats what I thought, but thought the standard ECU might be able to throw a bit more timing at the motor after it adjusted to the 100ron?

not reccommended for nissans older than 2004, not sure if this applies to imports... should notice a difference in stock ECU cars, AFTERMARKET TUNES- could be a problem, they dont adapt to different fuels, and ethanol has a higher oxygen content so could cause them to run lean...

I havent done any high tech fuel analysis or anything, but what i can tell you is filling up with v power racing in melbourne near the westgat and driving to albury on one tank the car ran great, smooth, heaps of power to overtake.

In albury they didnt have the racing one, so i went the shell v power.

Felt like driving a hyundai excel.

No power, chewed the fuel and ran like crap.

My 'test car' is a 1996 series 2 with some mild tuning, std turbo and other bolt on bits and pieces.

shell v power racing - good

shell v power - bad

Its a clear exmple of text book marketing strategy, same fuel but a differnt branding or name to be more unique from its competitiors and also attract more customers.

V power clearly sounds better, grabs your attention than Optimax

I beat you the V power fuel quality is still as same as the old one Optimax, as for the new one V power racing thats probably the improved fuel.

I regularily use vortex, and will continue. I had to fill up at shell and used v power and found that i didnt get as many kms as i normally do. i might try the 100 ron but i agree that it is purely a marketing strategy to change the name...dont think its different.

Its funny that V power racing is more expensive than V power when all they have done is take 5% of the expensive 98 octane petrol out and put in 5% ethanol which is very cheap...

Really, V power racing should be CHEAPER than V power, as it has ethanol in it.

http://www.skylinesaustralia.com/forums/in...&hl=Kennedy

SK is on the case about V power racing so I'm staying tuned for his results.

I'm on my 4th tank of VPR now and can definitly feel a touch more responsive than extreme

  • 1 month later...

I've been using V Power Racing lately, it seems to have a better response in my car and it runs very smoothly.

Had friends in the car have even asked me what have I done recently, its running so smooth.

Haven't had any problems as yet and been using it for a few weeks now, seems like good stuff ..one bad thing though..

I ain't liking the price!

Has anyone actually changed there old rubber fuel hoses?? I was under the assumption that ethanol based fuels will harden these older hoses that we are running making them crack and get brittle?? Can someone correct me here?

Cheers

A

Been using 100 ron in the R33GTST since January (almost 12 months). I put an adjustable FPR in recently to raise the fuel pressure and a GTR fuel pump. I checked the fuel lines at the same time and they are in perfect condition.

:D cheers :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...