Jump to content
SAU Community

Recommended Posts

Hi Guys,

I am after some info on the legalities of car mods in Victoria as I am moving to melbourne just before/just after christmas.

Could you please let me know if I will have any problems with the authorities using my car in Melbourne. I can probably keep the WA plates on it for a few months, but in the end I might need to register in Vic...or can I keep it registered in WA and drive on WA plates? Any knowledge on this will be greatly appreciated :O

Pics:

mods:

MECHANICAL

Garrett GT35R .82 exh housing

High mount exh manifold

Turbosmart 48mm pro-gate

Turbosmart V port BOV

Apexi N1 exhaust

Custom front & dump pipe with removable pipe to become screamer

Hybrid 100mm FMIC custom piping

Z32 AFM

Pod filter

Bosch 044 fuel pump

Sard 850c injectors

Sard fuel pressure reg.

Tomei poncams

Power FC & boost control kit

ORC cerametallic clutch

Blitz DCIV digital compact turbo timer

D2 Coilovers

Oil catch tank with breather

COSMETIC

400r front bar

drift side skirts

high spoiler

18" x 9" carlsson rs rims

falcon 265's front & rear

Nismo aluminium pedals

Nardi torino steering wheel

Bride brix seats

Pillar mounted defi gauges (water & oil temp)

Link to comment
https://www.sau.com.au/forums/topic/143401-moving-to-melbourne/
Share on other sites

  • Replies 61
  • Created
  • Last Reply

Top Posters In This Topic

keep the wa plates & rego

no hope of vic rego with all the crap on it

and if you get major defect in vic youll be sent to epa

which will check everything, no hope of passing with turbo, ecu, gate, catch oil etc

keep the wa plates & rego

no hope of vic rego with all the crap on it

and if you get major defect in vic youll be sent to epa

which will check everything, no hope of passing with turbo, ecu, gate, catch oil etc

Thanks Paul :O

Do you know how it will affect insurance if I have it registered in WA, and then need to claim in Vic?

Thanks Paul :)

If I join SAU VIC can you post the gear over here? or do I need to wait until I have a Melbourne address?

oh...and do you know if I will get much crap from the police because of the WA plates?

Thanks mate

:O

Jason....I've done the exact opposite and moved (albeit temp) from Vic to WA...you should've asked me about it at the drags :O

Forget getting your car rego'd in Vic with obvious big mods like on your car.

Basically the rules are that if you still have an address in WA you can keep your WA licence and rego. If not, you can keep them for a max of 3 months before you need to change them. It will only be after this 3 months that you won't have a leg to stand on in regard to police.

Any other questions feel free to PM.

Jason, as i told ya a while ago... you come with that car... pray.

And pray hard.

Its the only thing that might save you :O

If you get pinned and sent to the EPA, its pretty much remove every mod on the car and return it to standard.

You can join SAU-Vic anytime, we'll post to WA no problems :)

With WA plates you might get singled out more

Plus you car from the exterior doesnt exactly look standard... so you will be a target.

What area of Melb are you going to be in?

Insurance wont matter, but if you live in Vic for 4-5 months and are permanent, and you insure the car in WA as a residency, they i think you'll be voiding your policy.

Best to talk to the insurance company about that.

Vic - you can keep the WA rego/license for 3 months only. After that you wil get fined also if your pulled over and they find out you've been here for a while

:)

Jason....I've done the exact opposite and moved (albeit temp) from Vic to WA...you should've asked me about it at the drags :P

Forget getting your car rego'd in Vic with obvious big mods like on your car.

Basically the rules are that if you still have an address in WA you can keep your WA licence and rego. If not, you can keep them for a max of 3 months before you need to change them. It will only be after this 3 months that you won't have a leg to stand on in regard to police.

Any other questions feel free to PM.

Thanks Ant...I knew you came over from Vic, but didn't get around to asking you about it. If you will be at the member dinner and/or cruise I will have a chat to you about it :P

I can leave the car registered at my parents place here, so that will be ok, and insurance is combined with their car/house insurance :)

Vic - you can keep the WA rego/license for 3 months only. After that you wil get fined also if your pulled over and they find out you've been here for a while

Only if you don't have a residential address in WA Ash.....

and Jason I will be on the cruise mate. :P

Jason, as i told ya a while ago... you come with that car... pray.

And pray hard.

Its the only thing that might save you :)

If you get pinned and sent to the EPA, its pretty much remove every mod on the car and return it to standard.

You can join SAU-Vic anytime, we'll post to WA no problems ;)

With WA plates you might get singled out more

Plus you car from the exterior doesnt exactly look standard... so you will be a target.

What area of Melb are you going to be in?

Insurance wont matter, but if you live in Vic for 4-5 months and are permanent, and you insure the car in WA as a residency, they i think you'll be voiding your policy.

Best to talk to the insurance company about that.

Vic - you can keep the WA rego/license for 3 months only. After that you wil get fined also if your pulled over and they find out you've been here for a while

:)

Hi Ash,

I will be praying hard :P Most likely will be around the Brighton East area.

Surely there are guys there with pretty modded cars...how do they get around it?

your goin to get raped :) nice car btw

Thanks :P will have to keep my back to the wall then lol

Only if you don't have a residential address in WA Ash.....

and Jason I will be on the cruise mate. :P

Cool, I can have keep a residential address in WA :) Will have to question the insurance policy about being in a different state to the registered address :P

See you on the cruise :) ...or before :)

Only if you don't have a residential address in WA Ash.....

and Jason I will be on the cruise mate. :P

But if the same copper see's him once, and then 2-3 months later... and with WA plates its a standout for sure.

Questions will be asked... questions you dont really want.

Unless i was mistaken about how the rules work... you cant have a car rego'd in WA and be living in Vic (over 3 months) even if you have a residential address, its not classed as your residence if your not living there permanently

Hi Ash,

I will be praying hard :P Most likely will be around the Brighton East area.

Surely there are guys there with pretty modded cars...how do they get around it?

Thanks :) will have to keep my back to the wall then lol

They dont drive thier cars @ night

In high-risk areas

Dont hit boost anywhere

Have quiet exhausts

Stock wheels/body kits

etc etc. The less attention the better basically is the aim if you wanna try live :)

Either that or they have RB26's with low mounts and live a hassle free life :)

Brighton isnt too bad, im only 10mins away. But when you get here i'll show you where to and not to go haha ;)

Just be careful where you drive it and how you drive it. If you are doing a lot of night driving with few other cars on the road, you will stand a higher chance of being pulled over.

I have been driving around the Brighton area for 4 years plus on and off and never once seen a car being defected and only once a traffic car parked up. Its a nice area and several others could probably elaborate more like Sarahb.

Is it a daily driver as if not, several people drive more outrageous cars for weekenders only and dont get a lot of bother.

But if the same copper see's him once, and then 2-3 months later... and with WA plates its a standout for sure.

Questions will be asked... questions you dont really want.

Unless i was mistaken about how the rules work... you cant have a car rego'd in WA and be living in Vic (over 3 months) even if you have a residential address, its not classed as your residence if your not living there permanently

They dont drive thier cars @ night

In high-risk areas

Dont hit boost anywhere

Have quiet exhausts

Stock wheels/body kits

etc etc. The less attention the better basically is the aim if you wanna try live :)

Either that or they have RB26's with low mounts and live a hassle free life :)

Brighton isnt too bad, im only 10mins away. But when you get here i'll show you where to and not to go haha :)

haha cool ;) I will let you know when I arrive and we can go over the safe areas :P

Just be careful where you drive it and how you drive it. If you are doing a lot of night driving with few other cars on the road, you will stand a higher chance of being pulled over.

I have been driving around the Brighton area for 4 years plus on and off and never once seen a car being defected and only once a traffic car parked up. Its a nice area and several others could probably elaborate more like Sarahb.

Is it a daily driver as if not, several people drive more outrageous cars for weekenders only and dont get a lot of bother.

what is the problem with driving at night?

It will mostly be a weekender only, and it sounds like tht is the way to keep it :P

brighton has porsches and ferraris - but down beach rd i have seen a fair few imports.

This might be a very long way of doing things, but cant he borrow stock parts, install them, get the car registered and what not and then put back the mods? Thats if he wants to have Vic registration?

Bah - Ask Blaise about the secrets of the WA 'get out of jail free' plates.

He'll be in the grey Lancer being pulled over somewhere near Perth :P

So was it a good experience with the secret or a bad one? :P

yeah what ash said... try and take off the stickers, keep the noise down, and try and make it near legal height...

should be OK

oh and don't drive like a pratt

The height is sitting on 100mm which is the legal limit here...is it the same in Vic?

Thanks for all the info guys :)

Insurance shouldn't care where its registered, but you should give them the correct garaged address.

I don't know what it will be like with WA rego, but with NSW rego you can get the renewals sent to a Victorian address, so you don't even need a residential address out of Victoria.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
    • I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
×
×
  • Create New...