Jump to content
SAU Community

Recommended Posts

  • Replies 67
  • Created
  • Last Reply

Top Posters In This Topic

Hi guys

We ran a drift training day earlier this year, and are trying to do something similar next year. So stay tuned.

There are a number of groups who offer open drift 'practice' days too.

For general info - check out:

http://www.driftaustralia.com.au/

http://www.driftzone.com/

http://www.vicdrift.com/

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2706307
Share on other sites

There are practise days like the one on Wednesday this week that will be at Calder.

They have a section.

Its a bit hard to learn there because there is limited time and space.

You will find that most People who do so Have learnt on the street, which is very unsafe and not worth it.

Think about drifting before you get into it, do you want to do it full on, or you just want to give it a shot. If you just wanna give it a shot I reccomend its not worth it.

An incorrectly setup car can make it very hard and very very dangerous to drift, drifting is an expensive sport and it certainly makes it hard on the track if you dont have a well setup car. Lots of people can claim to drift, but going sideways is not the same as properly drifting like high speed entrys, clipping points, weight transfer etc.

If your passionate about it go for it!!! Ill be there at Calder this Wednesday and Winton next month.

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2706385
Share on other sites

Go put the hardest smallest width and profile tyres you can fit on the rear of your car and go have some fun. I've done it a few times and I think you'll find most of the people knocking it have never tried it or can't do it. The first time was fun on hard tyres but with the second time there with sem'i the car gripped to much after the first run.

Circuit is more fun for me but as you say you just want to learn car control drift is slower and therefore your less likely to hit something.

Go give it a go. If you just want to go for a thrash Calder isn't to bad. Apart from a few guys everybody there are just hacks.

Just don't drift under the bridge. Good luck with it.

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707324
Share on other sites

Yeah it seems to be the "cool" thing to pay out nissansilvia.. god knows why cause the interests of both are really very similiar.. Regarding drift there _are_ a lot of VERY experience drifters on NS.com but it's not a place for learning where to drift :S. Prolly best off going to a skid pan day (Which I know NS organise frequently in victoria) if you're brave you can take ya car to calder too :happy:.

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707376
Share on other sites

Actually going the smallest width and profile tyres is incredibly dangerous for a learning or experienced drifters.

Every Day, yes day, we see guys crash due to running skinny tyres on stock rims. You need grip to drift and small tyres dont provide that.

Lots of you bag out NS.com for no reason. You guys like race days and DECAS and they love drifting.

Funny most of the guys that do bag out NS have never been on the track. They think just because they did a DECA that they are track veterans because they are affiliated with SAU. When many NS members have attended both Calder and Winton and many skidpan days.

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707487
Share on other sites

lol the amount of retards on ns.com that go drifting in their owns streets is incredible...

almost every silvia owner thinks they are in the d1 everytime they go out onto the streets, im sure everyone see's that.

vicdrift is there for a reason, albeit expensive, its still there for this sort of thing to take place

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707523
Share on other sites

You are really misinformed and have made a huge generalisation.

I hardly ever see many silvias drifting on the street. Most of them are well behaved and drive properly.

On the other hand, every time I see a R32 or R33 they drive like total tools at double the speed limit and try showing off. Every time no doubts about it. In traffic where theres danger to others.

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707726
Share on other sites

now you are both making generalisations. the biggest factor that differentiates the two sites is age. and that is simply because of the cost factor. generally speaking tha people's cars on ns are cheaper than those here.

Dont get me wrong, there are some big expensive cars there but they are far and few between.

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707761
Share on other sites

You are really misinformed and have made a huge generalisation.

I hardly ever see many silvias drifting on the street. Most of them are well behaved and drive properly.

On the other hand, every time I see a R32 or R33 they drive like total tools at double the speed limit and try showing off. Every time no doubts about it. In traffic where theres danger to others.

yer bro im alwayz dosin down mah street in mah R32 dawg! itz lyk hektic when i rip da skidz past da popo n past da sk00l crossin wid kidz n shit y0!

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707783
Share on other sites

Could you explain to me Starionturbo how drifting with tyres that have little grip at slow speeds causes you to crash. Are you sure the drivers aren't try hard kids in thier auto's N/A's in industrial estates. I know there are a lot of them out there. I've met a lot of them selling parts.

From all of my driving experience it is a lot easier to get a car sideways at low speeds and hold it with hard smaller tyres and low profile.

Are you saying that you could drift better with 275mm wide semi comps compared to stretched 195mm wide hard old tyres in a r33 pressumably stockish r33.

Also if you need good rubber why do the drifters stretch 235mm tyres over 10inch rims and why do they sit the tyres on the roofs of buildings to let the go hard?

Only the good guys use good tyres with grip in high powered cars. Not learners! Good tyres snap back on decelleration to harsly for a learner.

It just seems that most drifters are talkers and seem to think thier D1 drivers.

We have some really good genuinely capable drifters in our club and this is only my opinion of other people I've met.

Your thoughts please....

Link to comment
https://www.sau.com.au/forums/topic/144927-drifting/#findComment-2707866
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
×
×
  • Create New...