Jump to content
SAU Community

Recommended Posts

haha, yep, its unavoidable :D. it can't be that bad? at least i hope not.
I got mine out a few years back, went under a general, and had all 4 out in one go. Only way to do it.

I was sweet pretty much from day one, no major swelling or bruising, just couldn't open my mouth all the way. But it all depends on how heavily impacted your teeth are, mine were fairly minor.

  • Replies 6k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Whilst we are on the subject I thought I'd share a little bit of information with you and explain why having your teeth pulled out hurts so much.

The first misconception is that the teeth are pulled out; I was told this only works with young children loosing their milk teeth. It was explained to me that teeth removal is a lot like removing a post from the ground. By pushing a pry bar down next to the tooth, pressure is exerted on the gum and tooth. If you push down hard enough (the whole isn’t big enough for both) something has to give, and the tooth pops up.

This explains why you feel so much force when they remove teeth, I had always wondered why I felt I was being pushed into the seat and nor pulled out of the seat.

See the the trick there Cubes is you keep the gas on till you legs and feet feel tingly, then you say...."Yup, i can still feel everything"....

Then when you slur it the 4th time "Yus....icunsillfill maaahh legzzz" is when they KNOW to turn the gas down :P

Thats when id let em shove a needle in me :)

nothing mate. will probarbly get materials to sand back the sil80 - weekend is fixing car time. yay!

ur car at boostworx atm? btw did u know that when daniel got his car tuned there, apparently hasnt even paid for it and was allowed to drive it way. ????

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you flushed the initial fluid yet? It should look like a rainbow unicorn shat glitter into it. 2nd or 3rd fluid change is when you party.
    • all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
×
×
  • Create New...