Jump to content
SAU Community

Recommended Posts

  • Replies 6k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I did, it was called the gorge montacute old norton summit mixup, but it has since been removed.

And the TT show with its japanese adelaide hills drifting scene, cant go thru the hills anymore I think its too risky to even drive under the speed limit in an import through there in daylight.

picked my car up at about 5pm today.. pulled over by the cops for the first time around at 9pm (no defect thank god!!)

"the reason we pulled you over is because your licence plates dont exist"... doh!! =P

mum was in the car at the time, and i just laughed.. was all good, the cops were pritty cool about it all *phew*

Was the XD Falcon S pack 351? iv owned some 351s xe and xd would'nt mind getting a xc 351

Nah unfortunately it was just a 250 X-Flow. But still went pretty well for a 6. Still haven't found a 6cyl with better low end torque, just a pity it didnt want to rev past 5k lol

ur bday is right now, happy birthday andy :P

Thank you! :)

Happy b'day Andy!

Buy those new turbo's for your B'day yet? ;)

Thank you!

2530's soon :)

happy b'day Andy :(

hope you have a great day :(

Thanksssssssssssss

Happy Birthday Andy

Cheers, ;)

happy bday Andy, we will get paully to come round in his bday suit for you.....

Thanks Dan, cant wait to see Paul wrapped in a pink bow

Hey its my bday too! :(

Happy Bday!

Happy Birthday Ben and Andy.

Hope you all get what you want all day long.

Cheers, :)

even if i came around in my bday suit it would still look like i was wearin a tuxedo, im a hairy italian bastard.

i like the hairy bit *sexy*

Paul' hairy back FTW!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...