Jump to content
SAU Community

Recommended Posts

  • Replies 84
  • Created
  • Last Reply

Top Posters In This Topic

hey burnsie.. i meant to ask last night.. I tried to check myself but it was too dark.

when your car is in direct sunlight, can you see a little bit of gold in it??

im spraying my bodykit at the moment, and cant tell if my car is still the stock nissan black or if its custom as it was resprayed just before I got it

  • 6 months later...

How weird, put the info into the gps took me there but iono i saw signs but it wasnt doing anything.. :stupid: Well then again there was a local resident car behind me so I was going normal speed and couldnt slow down.

Saw a white skyline going up it as i exited the place.

I don't know about this place... but have witnessed a similar thing with my own eyes in QLD... drove out to a hill at Toowoomba and on a really steep slope without the handbrake on, the car did not move at all (and no, it was not in gear lol).

It didnt go UP the hill but it was pretty bizarre!!

It was apparently pretty well known, took us a while (with a local) to find the proper spot!

doodz,

we'll have to show you where it is.

its not really marked out or anything - i cant really describe the actually place to get there, but when I see it I know that the spot!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...