Jump to content
SAU Community

Recommended Posts

hay guys

going to be driving my 34 GTT up to karratha next week which is like 1600km's or there abouts.

I have never done this drive but was wondering what things to do befor i go? or ways to save some fuel.

i will be doing a oil/filter change this week and all the normal checks, but is there any thing else to check?

Cheers

Justin

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/
Share on other sites

Sif a long drive :D

http://www.imports101.com.au/forum.php?thread=2352

Fuel consumption will be good because you will be cruising, but I think if you need 98 octane fuel you need to pack the jerry cans like me & Shayde did because I'm sure you won't be able to get it not far out of Perth ;)

Check your tyre pressures & bring along basic tools just in case something becomes a bit loose with the bumpy roads.

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2800460
Share on other sites

at long constant high speeds make sure u pump up your tyres to about 41psi

i just did a defensive driving course and its reccomended 32psi for short low speed trips 41psi for long high speed ones and 36psi for a good all round inbetween

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2800801
Share on other sites

at long constant high speeds make sure u pump up your tyres to about 41psi

i just did a defensive driving course and its reccomended 32psi for short low speed trips 41psi for long high speed ones and 36psi for a good all round inbetween

damn that seems arse about tit

long drives will actually increase the pressure in your tyres without putting any air in them just from heat and friction so if you have 41 psi in them to start with they will end up about 50 psi and u will be wearing out the centre of the tyre from over inflation

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2801083
Share on other sites

damn that seems arse about tit

long drives will actually increase the pressure in your tyres without putting any air in them just from heat and friction so if you have 41 psi in them to start with they will end up about 50 psi and u will be wearing out the centre of the tyre from over inflation

nope thatts the common myth, because theyre steel radials theyre made to handle it, they will be flat on the bottom, its if you unde inflate them though they will buckle and the middle will sit off the gound and the shoulders will wear, such as...

post-22805-1168162030.gif

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2801200
Share on other sites

Visit bp.com.au and check if BP Ultimate is available along the way. That was pretty much mine and Nathan's only concerns with the trip. I found I had best economy when I just with nothing on except for the stereo and with the window down. I tried using just the fan at the start and compared it to having the passenger window down a fraction.. and fan off lost.

Also, if you have a FMIC, you can put aluminium fly wire in front of it like I did. Saves trying to pick bugs out for the rest of your life... and best thing to get bugs off your paint is Windex surface cleaner. :)

Good luck and have a safe trip,

Shayde

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2801859
Share on other sites

cheers guys

i dont have a real need for 98 as the car is stock besides for cat back, only thing im worried about is the oil temp. in the city it gets to like 90-110degrees which i throught was high ne way.

will do other stuff what ya say thou

Cheers

Justin

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2801876
Share on other sites

cheers guys

i dont have a real need for 98 as the car is stock besides for cat back, only thing im worried about is the oil temp. in the city it gets to like 90-110degrees which i throught was high ne way.

will do other stuff what ya say thou

Cheers

Justin

should always be running 98 anyways, im pretty sure thats with a 34 anyways, i know 32 was reccomended from factory to use nothing less, i would assume that would be the case with any performance/turbo car ?

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2802986
Share on other sites

should always be running 98 anyways, im pretty sure thats with a 34 anyways, i know 32 was reccomended from factory to use nothing less, i would assume that would be the case with any performance/turbo car ?

not sure, i always run it on 98 in perth any way, i throught they recommended 95 premium? but i am most probly wrong

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2803105
Share on other sites

sup

take some CD's.... Lots. Preferably Phil Colins, perhaps even some Eminem just to mix it up abit lol. Make sure you have enough fuel to drive THROUGH NANUTARRA without stopping, fuel bandits. I think unleaded is like $1.80 something through there.

Fortescue roadhouse is a couple hundred kays up the road and a lil more reasonable price wise.

Pretty sure you cant get ultimate after Coral Bay, but i doubt youll be pulling into there. Carnarvon also has ultimate

You obviously live in karratha yea? Should catch up for a cruise sometime....

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2809641
Share on other sites

Ive driven my car to perth and back to Broome. 2200km inland road approx. Definately bring the octane boost, 2 or 3 bottles will do. Most places have premium 95 octane, with a couple 98. I only fuelled up at 4 places on a 1 way trip and that was with 1 jerrycan. From broome 2 years ago, cost me about $380 in fuel and octane boost.

Sandfire, headland, newman, wubin. and then the jerrycan. Im pretty sure thats how it went. Roughly 450kms to a tank, and thats off bp 95 octane with octane boost.

Stick to 100-110km/h as anything over your doing 3000rpm or more (in a SII R33 Sedan 5 Speed anyway).

Do all the oil, water, tyre pressure checks before you leave, and check tyre press at each fuel stop (i did, i got a techhhhhh screw through a tyre at poxy sandfire roadhouse, 300km from anywhere).

good luck and dont stress too much. The RBs handle that trip with ease.

cheers

Evil

Link to comment
https://www.sau.com.au/forums/topic/150355-long-drive/#findComment-2815909
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...