Jump to content
SAU Community

Recommended Posts

I have a late 1995 model skyline, with Series 2 Engine. I have a problem when it gets hot, it basically stalls when I press the accelerator quickly, then release. It also starts to run rich after it has been running for a while, I have changed the ECU, changed the AFM, changed the O2 Sensor, Spark plugs, changed the oil, oil filter, fuel filter... what is involved in keeping these cars running ?.. what decides the fuel mixture, what could be causing this problem ? does anyone know a full list of sensors, and components? if anyone has any idea, just let me know.. I am going to try a few other AFM's, and O2 sensors, to make sure there are a whole pile of faulty ones..

regards

shane

Link to comment
https://www.sau.com.au/forums/topic/15051-car-problems-r33-skyline/
Share on other sites

Shane,

Still racking my brain tryning to think what it is and I still got no idea.... and for the rest of you

Swapped AFM for working one

Swapped ECU

Swapped O2 sensor

Full service

still not fixed??

It won't be cooler piping cause that would be a consistent problem, not 10 minutes after driving, not the BOV cause it would do it when it's cold too...

The problem is after 10-15 minutes of driving the car goes stupidly rich.... when cars warm up the ECU actually runs them leaner (like a choke)....

Hmmmmm..... any one got any ideas cause I'm stumped!

Doc.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...