Jump to content
SAU Community

Recommended Posts

I got rear ended this morning. Im kinda bummed about it because I got a speeding fine yesterday on my 21st birthday, and I think I lost my license. The worst thing is that they pegged me for 95 in a 60 zone leading on to an on-ramp of the freeway :) . Kind of an unfair spot, I think.

post-24834-1168907240.jpg

post-24834-1168907250.jpg

On the plus side I got birthday sex :)

Link to comment
https://www.sau.com.au/forums/topic/151934-my-poor-damaged-skyline/
Share on other sites

sorry to see whats happened, not a fair spot at all!!

it may be time to change your sig..

"--------------------

Buy my car!! R33 Series II Sedan automatic.. Awesome condition.. Clicky Clicky!"

sorry - i had to say that haha :) maybe make it

"--------------------

Buy my car!! R33 Series II Sedan automatic.. i get sex.. Clicky Clicky!"

haha

lol @ bday sex; geez mums can be so kind and thoughtful sometimes, hey?!?!

hahaha sorry man, joking, trying to get ya to laugh - good work on that account tho

With the speed camera and the area it was situated in, etc, you have all the right to go with it to court, plead for leniancy etc.

As for the rear end, man bad luck. Thats mighty depressing. Hope it all irons out ok

Now there's an emotional couple of days =\

Bad luck about the fine (you should fight I say!) Good work on getting some =D

I recently parted ways with a long term GF and my Series II GTS25T - Upgraded to a GTR and currently 'upgrading' to a hotter GF :wub:

Sometimes these kind of things are really blessings in disguise!

Good luck!

= $10k repair bill before you can even blink.....

I hear East Bear body kits are really nice.....

You were right, and the panel beaters are booked solid so might end up being a write off!

Thanks for your support guys it means a lot :) . I wont be fighting the fine as I'm moving really close to my work so I'm going to take it on the chin, and save some money for 3 months!

I recently parted ways with a long term GF and my Series II GTS25T - Upgraded to a GTR and currently 'upgrading' to a hotter GF :dry:

i upgraded from a 33 to a 34 GTR

but i wish i could upgrade my wife too :)

back to the topic, 95 on a 60..ouch$

they set the camera there on purpose, bet they'd have a 60 sign right next to it too

bastards

bad luck dude, but as was said earlier, may be a blessing in disguise. to upgrade to a GTR!! :)

Il take a pot shot and say that u got pinged coming off canning hwy and that 60 zone to manning road. I know alot of people that been caught on that one. (thats the only one that i know on the freeway that's so stupid. )

Hope everything works outok.

dan_the_man

I had a little shunt, had to replace the rear bar, rear panel, bumper re-inforcement, and spray the whole rear end.

To spray the whole rear end you also have to spray right over the roof and down the A pillers, as it's one section of steel.

My damage was HARDLY visibled, but the repair did need to be performed.

Total cost was $7,300.

The accident I see above needs

rear bar

rear panel

boot panel

brake lights x 2

boot

both quarter panels

bar reinforcement

window seals x 2

The remove and refit on those parts alone is going to be $10k

Then there's the labour to pull the car straight etc etc.

I put a beer on Write off.

Sorry man.

did you have insurance? or should i say did the person who hit you have 3rd party?

Ive always thought that meant their insurance company has to pay for it if at fault? so new car for you?

Edited by jjjDavey

The assessor just called me and said its most probably going to be a write off, however I need to get a quote because if the accident goes to court they need evidence that it was actually written off.

thats some terrible damage mate, i wish you were in adelaide and it came as a repairable write off, id be pestering you and offering cash for your complience plate........

hope they got the wrong car or theres some obstruction in the speeding fine picture

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
×
×
  • Create New...