Jump to content
SAU Community

Recommended Posts

G'day people,

I'm having trouble with my aircon. When a/c is turned on via climate control amp, the compressor doesn't turn on. The only way a/c can be turned on is if terminals 5 and 3 from the a/c relay is bridged out. I'm not good with my electrics but i have the following info that may help fing what the problem is.

with ignition left off: 0Volts in all terminals 1,2,3,5

terminals 1,2,3 are 0 ohms. 5th terminal has around 12.5 ohms varying

with ignition turned to ON: 0 volts in terminals 1 and 3, 11.5 volts in terminal 2, 11.4 in terminal 5

terminals 1,2,5 are o ohms. terminal 3 has .88 ohms.

i hope this helps. Cheers :sorcerer:

Link to comment
https://www.sau.com.au/forums/topic/155956-r32-gtr-aircon-problem/
Share on other sites

Yeah, the air comes out cold. I've checked all fuses. I've also checked the diagnostic system for the a/c amp but it only came up with the sun sensor, only because i did it in the shade. I think it may be a problem with the a/c amp or somewhere in the wiring harness, but too much wiring confuses the hell outta me. I've checked the wiring diagram for the a/c in the repair manual under HA-3. If anyone has that diagram and could roughly point out where there may be a bad connection, they are bloody legendary.

Id say its low on gas. Low enough to not engage the clutch on the compressor but still just enough to get the air cool.

So get the system leak tested, repaired, and regassed.

Edited by Godzilla32

Id be doing the same.

Get it checked out properly. With a set of guages on the system the problem can be isolated in seconds.

If its the wiring issue then obviously you will be looking at the relay switching circuit which is not overly complicated.

Having a similar problem with mine can bridge the relay and compressor kicks in cold an lovely ran for an hour or so like this then poped the fuse. Checked out the compressor coil pin 5 on the relay in the manual drawing mentioned earlier measures 3.5 Ohms as per the manual (the 12.5 ohms ed is seeing would suggest the coil clutch to me). Looking at said drawing the only thing that can stop the signal from the ECCS control unit is the dual pressure switch. Was wondering if anyone knows if the dual pressure switch will stop the compressor switching on if pressure is to high or only if its to low. R134 gas has much higher head pressure than r12 (the original gas) and if its still the original switch this may be the problem or part of it.

My mate tested the pressure switch and he said it was fine. I think it may be a problem with the a/c amplifier. My mechanic friend was crossing over wires from the fan relay to the a/c relay. I dont know why he did that but must have fried it. The a/c used to work before he did this. He was trying to find out why my thermo fan wouldn't turn on.

  • 2 months later...

So you have checked you don't have a dud sensor?

Throw it in to diag mode and have a look at the temperature values from the 4 sensors or what ever it is.

I had a dud cabin air inlet temp sensor, constantly reading -30degree's.. Obviously it would refuse to engage the aircon's compressor as it was too damn cold. lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...