Jump to content
SAU Community

Sliding Performance Sponsored R32 David Browne

Slide

By Slide,
in General Automotive Discussion

 Share

Recommended Posts

drifterx Contributor

drifterx

Posted
Posted

thank you for the nice comments, and a big thank you to aaron from SLIDIG PERFORMANCE for the help also finacial backing this year, the car has been fitted with,

new series avcr, easy to use and very accurate

HI FLOW useing BIAGIO internals, 1.2 bar

tuned by gavin wood auto tech

first test was at paklands, low speed track. car ran awesum , this weekend will be at qld raceway were the real speed is needed.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Murray_Calavera
      Steps to DIY sanding car back ready for respray....

      By Murray_Calavera · Posted

      It happens, that's what your single stage filler is used for.  If it is still visible after the 3 coats of 2k primer, it will be visible after the paint is laid down.  Its hard to give 100% perfect advice without being there in person, I'm very tempted to say stop where you are, fill your pin holes with a single stage putty first then keep going. 
    • TurboTapin
      CD009 RB Conversion

      By TurboTapin · Posted

      New or used transmission? Alignment will be the same with engine running or not. If new, i'm presuming it's a clutch release bearing size issue. If used, are you certain it's a CD009/A and not an older CD008 or less? They had known synchro issues. In my opinion, these transmissions should always be purchased new, they're dirt cheap and you avoid dealing with old revisions. 
    • soviet_merlin
      The Evolution Of "night Fury"

      By soviet_merlin · Posted

      I like your thinking! Looking forward to see how it turns out.
    • MBS206
      How can I remove this adhesive?

      By MBS206 · Posted

      You've got yourself a good old game of have fun. That shit is annoying as hell to remove. Thankfully for you, yours is on metal, most of the stuff I take it off is plastic, so typically hear guns are out. I normally end up continually dragging my thumb with pressure over it to get it to peel up. Eucalyptus oil then works well for getting residue and last remnants off.   Edit: plastic scraper might be worth while too. One that'll dig into the foam tape, but not scratch the paint.
    • jez NF
      The Evolution Of "night Fury"

      By jez NF · Posted

      So I ride and race motorcycles for fun and have always used a van to transport my track weapons. Figured towing a racebike with a skyline would be different and if done right could - "look fully sik" or quite cool for us grown ups lol. Pic of yours truly on two wheels I also have a trailer already kitted out to transport my bikes ...and I have a spare set of rims that match the car that I was going to rebarrel to get deeper dish at some stage but they have just been gathering dust. Sooooooo it is only logical.... Stay tuned !!    
×
×
  • Create New...