Jump to content
SAU Community

Recommended Posts

Ok we now have enough for the group buy to go ahead.

PM with my bank details has been sent, everyone needs to pay ASAP! The quicker everyone makes payment the quicker I can order the boots so the you all get them earlier.

Make sure you reply the PM with your address and name.

And dont forget to leave trader feedback when you receive the boots!

  • Replies 518
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

talked to the supplier last week, he said he posted them and they should arrive monday.

there is 3 spare sets because of people who have not replied emails or pulled out of the group buy, so let me know if you are interested and you wont have to wait for the next group buy

Payments received and boots express posted!

Also don't forget to leave positive trader feedback once you receive them and I will leave the same for you!

If you are in the AusPost express area codes you will receive it tomorrow (sept 19) otherwise you should receive them thursday or friday

there is still a few sets left over because of people who pulled out of the group buy so let me know if you want one and there wont be a waiting time until next group buy

Also don't forget to leave positive trader feedback once you receive them and I will leave the same for you!

Edited by pablo101

GTR 400 payment recevied.

There is still a few sets left over because of people who pulled out of the group buy so let me know if you want one and there wont be a waiting time until next group buy

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
    • It's been quite the ordeal but hey, at least you figured it out.
    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
×
×
  • Create New...