Jump to content
SAU Community

Recommended Posts

Hey

I have a GTST series 2 R33 and i want to change the BOV because its not loud enough for my liking! but i dont wanna get defected either.... is there anything that i can change it to to make it louder? or am i stuck wid the standered one? What have you guys and girls done? anything that is a direct swap over of the standered one?

Cheers

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/
Share on other sites

We are in SA, so yes, it is illegal to have one Adz.

You need a retune if you disconnect your stock BOV apparently to reconfigure your idle.

The Atmo one will go where your stock one is with a flange that migth have come with your BOV if it was specific to our car. I am getting an adaptor made up for my Blitz SS BOV to go where the stock one is cause I want something a bit stronger and stainless in the stock ones place.

You will find if you block your stock one up (Thread in DIY section) then you will notice the car will stall when you approach lights, in parking areas, etc etc. So the only thing that fixed this is a AFC or a ECU apparently.

And yes, under normal driving if you do it without a retune, you will notice some fully sik woosh woosh action. lol. :)

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3054254
Share on other sites

We are in SA, so yes, it is illegal to have one Adz.

You need a retune if you disconnect your stock BOV apparently to reconfigure your idle.

The Atmo one will go where your stock one is with a flange that migth have come with your BOV if it was specific to our car. I am getting an adaptor made up for my Blitz SS BOV to go where the stock one is cause I want something a bit stronger and stainless in the stock ones place.

You will find if you block your stock one up (Thread in DIY section) then you will notice the car will stall when you approach lights, in parking areas, etc etc. So the only thing that fixed this is a AFC or a ECU apparently.

And yes, under normal driving if you do it without a retune, you will notice some fully sik woosh woosh action. lol. :)

I wanna keep a BOV just have one thats louder.

And i have a POD already mate

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3054282
Share on other sites

Yeh, like he said, you will need a retune, it might not be too bad (the stalling) as with my bov blocked off it would stall maybe once a day. Best bet if u don't want a bov but you want sound is to go a mesh pod. Go a DRIFT pod or similar, just make sure the element is pretty thin and it will be loud enough

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3054285
Share on other sites

you underestimate the stalling my friend... it is possible to happen ANYTIME you stop, if you dont have ur foot over accelerator as you brake your f**ked, trust me lol.

It'll hunt for AFR like a c**t, go up and down the revs like crazy then if u dont balance it out with the accelerator ur stuffed, can happen anywhere, even while you are moving downhill, put it in to nuetral to double clutch cause ur synchros are screwed then the car stalls as you are rolling at 70km/h...

you need a retune if you remove the stock bov, and then the new bov u get needs to be tuned too...

ADAM, a vent to atmo BOV is one that VENTS TO ATMOSPHERE, ie, has a little trumpet or filter or whatever is aftermarket these days are pretty much all vent to atmosphere, thats the valve that creates the phshhhhhhht noise. k thnx bye lol.

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3054344
Share on other sites

you underestimate the stalling my friend... it is possible to happen ANYTIME you stop, if you dont have ur foot over accelerator as you brake your f**ked, trust me lol.

It'll hunt for AFR like a c**t, go up and down the revs like crazy then if u dont balance it out with the accelerator ur stuffed, can happen anywhere, even while you are moving downhill, put it in to nuetral to double clutch cause ur synchros are screwed then the car stalls as you are rolling at 70km/h...

you need a retune if you remove the stock bov, and then the new bov u get needs to be tuned too...

ADAM, a vent to atmo BOV is one that VENTS TO ATMOSPHERE, ie, has a little trumpet or filter or whatever is aftermarket these days are pretty much all vent to atmosphere, thats the valve that creates the phshhhhhhht noise. k thnx bye lol.

ok so legally long story short in SA your stuck wid the standered one all other ones are illegal????

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3054380
Share on other sites

I have just removed a turbo smart vee port BOV from my stock ecu'd r33. Stalling ??? not once in the severals weeks i had it on there....

The only thing i noticed having a atmo BOV on my r33 was a little bit of back fire upon gear shifts sometimes.. Did not sound bad at all.

And the little puff of black (barely noticable) when boosting @ 10 psi and gear change..

The reason I removed it is cause i wasn't a big fan of the noise.

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3055240
Share on other sites

I don't quite understand.. I don't doubt whether it would or not, but WHY would and aftermarket bov make you stall on idle?

Also, is there many aftermarket bov's that give better performance but don't make more noise?

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3055398
Share on other sites

I have just removed a turbo smart vee port BOV from my stock ecu'd r33. Stalling ??? not once in the severals weeks i had it on there....

The only thing i noticed having a atmo BOV on my r33 was a little bit of back fire upon gear shifts sometimes.. Did not sound bad at all.

And the little puff of black (barely noticable) when boosting @ 10 psi and gear change..

The reason I removed it is cause i wasn't a big fan of the noise.

the smoke and backfire is from putting too much fuel into the system... the car computer reads a lot of air rushing along (before BOV) and when you put the pedal down, adds fuel to the mix... if all that air is out in the atmosphere, it takes a second for the right amount of air to get to the block... if its recirculating, then there is a lot of air in there already, ready to go into the block...

I don't quite understand.. I don't doubt whether it would or not, but WHY would and aftermarket bov make you stall on idle?

Also, is there many aftermarket bov's that give better performance but don't make more noise?

runs your car too rich and it stalls... Im not certain, but i think cars that are having this problem should go get a tune...

Link to comment
https://www.sau.com.au/forums/topic/164882-bov-legals/#findComment-3055543
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This looks great! Awesome to have the 5 speed with an LSD in this. The Recaro's look like SR2's or SR3's. It's a shame they've been retrimmed as they would have looked sweet in their original colours. I think I'd want my agent to be a little more up front and informative too. I've never imported but I reckon it would make me a little nervous, so the more info the better.
    • Thanks for doing that Duncan! Makes you a good person in my books. We don't get kangaroos or wombats here. But we have bats and it's similar. AFAIK it's often the mums with a baby attached that get hit because they drop lower when starting from a tree. If you hit an animal, check on it. https://www.ifaw.org/au/resources/wildlife-rescue-app An app to get the closest wildlife rescue contact.
    • My dream is also to have a proper hoist, but I don't think it will ever happen. My quickjack is probably as close as I'll ever get, it really is very good though. 
    • Yeah we keep on in the dailies, it is pretty poor how many animals get hit and the driver leaves without checking....have saved a couple of little ones over the years. Bit of a gruesome job though, pouches generally need to be cut open because they are so tight and often the joey doesn't realise mum is gone so they are still locked onto the teat. I checked the modules in front of the DS wheel where an oil cooler should go.... There is the radar unit - that can go for race use) One of the 2 HX water pumps, the silver cylinder. That needs to be kept but might be able to be relocated But the bad news, the big computer mounted vertically in front of the wheel (blocking any potential air exit) is the electric steering computer. That is required until/unless i do a hydraulic steering conversion, and in CAD based modern car design it is not like I can just pop a big unit like that somewhere else (plus the loom would be too short anywhere else too). So, the passenger side is OK to clear out (just use a smaller washer reservoir, potentially elsewhere), but the DS no beuno
    • Well, all the best with the new camry It was interesting to hear about the UK process, it is generally a lot more streamlined here with a shipping agent looking after all the import side (noting the exact final price can still be a surprise.....) and I've used a few different brokers on the japan (or US) side, and never had any trouble with any of them....luck of the draw I guess. You mentioned you didn't get the auction sheet (understandable since you bought it from a dealer, not auction), but I always try and get hold of that because they are pretty thorough. I've imported 2x R grade vehicles over the years and both were fine, repairs in Japan are pretty thorough compared to here in Oz.
×
×
  • Create New...