Jump to content
SAU Community

Recommended Posts

hay every one,

2 quick quistion is it true if you get a aftermarket computer,pfc/heltec/motec/ems/ect,ect,ectin the r34

do you loose the function with the :Traction Control

I ask cos i got a new ecu put in,then he told that i will loose this function

an also the engin light,the tcs,an the slip lights in the dash permanently stays on

is this right or have i been screwed an he has'nt done it right

also now it takes about 4-7 sec to even start,

were as before it turnd over straight away.an when it does start the frist three sec it sound like its going to stall

after that it goes to 1500 revs until it warms up then drops to 900 revs

does it sound like he has'nt tuned if properly

thanks

Edited by SMOKE'M

did you get a new ecu or just a chip? I got a chip & tune done in my R34, and NOT a problem in the world with TCS or start up. take it to get looked at by a new workshop and a new tune. may make ur car run better & they may find the reason why ur TCS isen't working. and the slip light woulod be shitting me off if it stayed on.

"IF" the ecu has stuffed with the TCS and wont work again, get some wire snips and cut the wire to the Slip light asap. haha

did you get a new ecu or just a chip? I got a chip & tune done in my R34, and NOT a problem in the world with TCS or start up. take it to get looked at by a new workshop and a new tune. may make ur car run better & they may find the reason why ur TCS isen't working. and the slip light woulod be shitting me off if it stayed on.

"IF" the ecu has stuffed with the TCS and wont work again, get some wire snips and cut the wire to the Slip light asap. haha

Where'd you get yours chipped if I may ask?

Sounds like a few minor issues. I doubt TCS will work as the stinger doesnt appear to support it. You may have idle issues.

Why dont you ask the shop why it doesnt start up as fast as before and why the lights are always on? If you did then what did they say?

you have to check if the ECU has Plug N play base map on it. If you use chip in your stock ECU or aftermarket with plug N play such as PFC, then the should work fine...

My guess is your car is tuned with ECU which does not have a base map, the ignition delay is caused by poor cold start tune. It is easier to tune while engine is hot and running however cold start is tricky, as by the time the tuner got the approximately right tuning, the engine would have been warm. Then to wait for the car to cool down again takes 2-3 hours, which I highly doupt the tuner will put the car back on the dyno.

This is also consistent with your idling problem, sometimes if the tune is not done properly the car will actually stalls on its own, you got to give it a bit of fuel... you won't have this problem once engine is warm no?

hay every one,

2 quick quistion is it true if you get a aftermarket computer,pfc/heltec/motec/ems/ect,ect,ectin the r34

do you loose the function with the :Traction Control

I ask cos i got a new ecu put in,then he told that i will loose this function

an also the engin light,the tcs,an the slip lights in the dash permanently stays on

is this right or have i been screwed an he has'nt done it right

also now it takes about 4-7 sec to even start,

were as before it turnd over straight away.an when it does start the frist three sec it sound like its going to stall

after that it goes to 1500 revs until it warms up then drops to 900 revs

does it sound like he has'nt tuned if properly

thanks

Hmmmmmm, sounds just like the problem I had when I had a Microtech installed. No AFM causes heaps of things to not function as they should. Changed to a PFC with a Z32 AFM and bingo all is good again. Does yours still have the AFM?

Cheers

Muz

Edited by Muz

it may be that the TCS/ABS computer required signals from the ECU , such as TPS . This is similar to how the auto works .

This means those signals must be replicated by the ecu (which the r34 pfc would do) or you may be able to bridge the sensor outputs required for TCS . this is often how other ecus such as motecs and autronics are installed to work with tricky features like traction control , automatic gearboxes , stability control etc

Edited by arkon

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...