Jump to content
SAU Community

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

ummm....just a thought.....have you guys stopped for a second and wondered if thread starter was actually being sarcastic :)

The question bro, is have you stopped for a second to think that the dude actually meant it... let's face it, for the coppers, the car is not too bad... I mean, it's not bad... quite nice... but I would say SUPERCAR... damn yo!

Guys, you got this all wrong!

It's not actually an XR8, it's just a police conspiracy to make it LOOK like an Xr8.

It's actually an experimental new police car... the XR9!

Yep, 9 cylinders. The extra one is usually turned off, but kicks in when at high speeds! Genius!

The thing on the roof is actually a remote control receiver. Police in a helicopter can manouver the car and ram your butt while they stay safely in the helo. It's also useful for freaking out the stoners who drive to Macdonalds at 4am.

Ok, so I'm bored. It's an Xr8. yay.

Almost makes me wish he's posted that jap skyline cop car again.

i used to work @ cartech (before enfield auto auctions went broke) where all nsw police vehicles were put together and all mods done to them.

theyre nothing special, just a xr8 with the so called "chip" installed. the "chip" is just another computer circuit board installed in them to wire up all the radars,terminals and other bullshit they have to run.

main problem they had was that with all the digital recording equipment they started using the cars were overloading and shitting themselves mid pursuits, which led them to install big arse capacitors to hold power in them during the chase.

drove a few cop cars through the yard and around the carpark area, when they came back to be stripped and sold as stock standard cars, they werent worth much anymore.

i used to work @ cartech (before enfield auto auctions went broke) where all nsw police vehicles were put together and all mods done to them.

theyre nothing special, just a xr8 with the so called "chip" installed. the "chip" is just another computer circuit board installed in them to wire up all the radars,terminals and other bullshit they have to run.

main problem they had was that with all the digital recording equipment they started using the cars were overloading and shitting themselves mid pursuits, which led them to install big arse capacitors to hold power in them during the chase.

drove a few cop cars through the yard and around the carpark area, when they came back to be stripped and sold as stock standard cars, they werent worth much anymore.

Thanks for the info... damn.... good stuff... insteresting...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...