Jump to content
SAU Community

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

ummm....just a thought.....have you guys stopped for a second and wondered if thread starter was actually being sarcastic :)

The question bro, is have you stopped for a second to think that the dude actually meant it... let's face it, for the coppers, the car is not too bad... I mean, it's not bad... quite nice... but I would say SUPERCAR... damn yo!

Guys, you got this all wrong!

It's not actually an XR8, it's just a police conspiracy to make it LOOK like an Xr8.

It's actually an experimental new police car... the XR9!

Yep, 9 cylinders. The extra one is usually turned off, but kicks in when at high speeds! Genius!

The thing on the roof is actually a remote control receiver. Police in a helicopter can manouver the car and ram your butt while they stay safely in the helo. It's also useful for freaking out the stoners who drive to Macdonalds at 4am.

Ok, so I'm bored. It's an Xr8. yay.

Almost makes me wish he's posted that jap skyline cop car again.

i used to work @ cartech (before enfield auto auctions went broke) where all nsw police vehicles were put together and all mods done to them.

theyre nothing special, just a xr8 with the so called "chip" installed. the "chip" is just another computer circuit board installed in them to wire up all the radars,terminals and other bullshit they have to run.

main problem they had was that with all the digital recording equipment they started using the cars were overloading and shitting themselves mid pursuits, which led them to install big arse capacitors to hold power in them during the chase.

drove a few cop cars through the yard and around the carpark area, when they came back to be stripped and sold as stock standard cars, they werent worth much anymore.

i used to work @ cartech (before enfield auto auctions went broke) where all nsw police vehicles were put together and all mods done to them.

theyre nothing special, just a xr8 with the so called "chip" installed. the "chip" is just another computer circuit board installed in them to wire up all the radars,terminals and other bullshit they have to run.

main problem they had was that with all the digital recording equipment they started using the cars were overloading and shitting themselves mid pursuits, which led them to install big arse capacitors to hold power in them during the chase.

drove a few cop cars through the yard and around the carpark area, when they came back to be stripped and sold as stock standard cars, they werent worth much anymore.

Thanks for the info... damn.... good stuff... insteresting...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...