Jump to content
SAU Community

Recommended Posts

ok when im idling and i turn on my air con, the car revs up to 1500rpm, then drops to 700rpm like it does that quick goes up and down up and down until i turn it off or wait until it settles down, which it does after a while, also its only blowing hot air now (could need a re-gas, but that was done only just a year ago how come its gone so quick), and sometimes when i press mode to skip through where i want air blowing it makes a clicking sound loud and for atleast 30 seconds, heater works good though, although last time i used my a/c was back in april lol and thats when every time i used the a/c the gears were hard to get into, especially 1 and reverse LOL

someone help ^_^ stupid climate control

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/
Share on other sites

ok when im idling and i turn on my air con, the car revs up to 1500rpm, then drops to 700rpm like it does that quick goes up and down up and down until i turn it off or wait until it settles down, which it does after a while, also its only blowing hot air now (could need a re-gas, but that was done only just a year ago how come its gone so quick), and sometimes when i press mode to skip through where i want air blowing it makes a clicking sound loud and for atleast 30 seconds, heater works good though, although last time i used my a/c was back in april lol and thats when every time i used the a/c the gears were hard to get into, especially 1 and reverse LOL

someone help ^_^ stupid climate control

There is a diagnostic check that you can run to tell what the problem is.....

Start car and hold down the OFF button for 5 seconds and it will go into diagnostics mode.....

It will then show you any error codes.

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3382107
Share on other sites

Probably just coincidence that the gear selection is awkward when A/C on.

The ECU will raise the idle revs when it gets the signal that the A/C is operating. The hunting for idle is probably the AAC valve.

Try holding the "cold" button until the unit displays "FC" (full cold) - does it still blow hot?

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3382290
Share on other sites

There is a diagnostic check that you can run to tell what the problem is.....

Start car and hold down the OFF button for 5 seconds and it will go into diagnostics mode.....

It will then show you any error codes.

What's it mean if all the lights light up. all good or all bad.

BTW where do you find all these diagnostic tests?

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3382719
Share on other sites

Probably just coincidence that the gear selection is awkward when A/C on.

The ECU will raise the idle revs when it gets the signal that the A/C is operating. The hunting for idle is probably the AAC valve.

Try holding the "cold" buton until the unit displays "FC" (full cold) - does it still blow hot?

so i started the car and held the off button but nothing happened LOL wtf!! cold button? the blue one? its down to 18c but still hot as, sux coz its getting real hot nowadays + i cant believe it needs a regas so quick!!

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3383432
Share on other sites

so i started the car and held the off button but nothing happened LOL wtf!! cold button? the blue one? its down to 18c but still hot as, sux coz its getting real hot nowadays + i cant believe it needs a regas so quick!!

It could be a leak in your system or you've got a stuffed motor (motor which controls the hot/cold). First thing is try the diagnosis to see what's going on before ripping out your dash.

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3384251
Share on other sites

it doesnt want to go into diagnostic mode? :S the clicking isnt normal, as it never happened until recently :) damn ripping out the dash.....oh well perfect time to install some gauges etc etc, i'll try a regas 1st then see what happens, if theres a leak in the system how do i go about fixing that, can it be a diy? or needs to be done professionally

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3386433
Share on other sites

it doesnt want to go into diagnostic mode? :S the clicking isnt normal, as it never happened until recently :D damn ripping out the dash.....oh well perfect time to install some gauges etc etc, i'll try a regas 1st then see what happens, if theres a leak in the system how do i go about fixing that, can it be a diy? or needs to be done professionally

If the car is more than 5 years old the rubber hoses were made to handle R12 refrigerant - the cocktail of gas used now is molecularly smaller and will weep through the pores in the hose - common thing - if you re-gas it will slowly deplete again, only way out is to try and get some R12 - but i doubt if you will. The hoses have to be replaced.The reason it is hunting is because oh the LP switch sensing a drop in pressure and the compressor clutch is comming in and out. sorry

:)

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3386559
Share on other sites

it doesnt want to go into diagnostic mode? :S the clicking isnt normal, as it never happened until recently ;) damn ripping out the dash.....oh well perfect time to install some gauges etc etc, i'll try a regas 1st then see what happens, if theres a leak in the system how do i go about fixing that, can it be a diy? or needs to be done professionally

The clicking noise is worn out gears. The gears which move your vent direction is worn out and the motor slips while trying to turn it.

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3387219
Share on other sites

yeah same, stupid aircon fan, errm expensive to replace these gears? motor or whatever? how about the hoses? its too bloody hot :) dont even feel like smoking coz its so hot, how about the problem with my gearbox? like it only happens when i turn the aircon on (cold) on heater its fine, once i couldnt get into any gears it would crunch even when i was at a stand still, but if i gave it a rest and came back few hours later would be fine, hence the reason i havent used my aircon for ages lol, try parking without being able to get into gear :P

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3388401
Share on other sites

That idle up then down is the clutch engaging the aircon compressor, which increases the load on the engine, and the AAC valve increases your idle to compensate so it doesnt stall. The drop down occurs when your thermostat is at the correct temperature and the clutch is disengaged from the compressor. Perfectly normal unless the Aircon switches aint working. The clicking sounds can also be the vents opening and closing, its a common problem apparently, the little plastic teeth come off the rails so im told??? but requires the whole dash to come apart - stuff that

I dont think the size of the molecule matters witht the aircon hose, I think its more the press fittings which are the issue, or any threaded joints especially if youve been moving/bending aircon pipes/hoses about the place to get your FMIC to fit. Take it to an aircon place, they inject a die into the cooling system to check for leaks, make sure you tell them o/wise theyll just fill it up and send you on your way - they love it, cos you come back in six months to get the same thing done. O/wise keep the windows down and make sure your heaters turned up - problem solved :D

Link to comment
https://www.sau.com.au/forums/topic/187370-air-con-disease/#findComment-3392553
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I hope it's actually possible. This is a write off in insurance world.
    • Yup. 2-way with shallow ramp angles. Still works.
    • That was the first session so not a lot to take from the day. It was low 20s ambient and the coolant had got to 110 (and obviously had some pressure!) so that still needs to be addressed. I haven't downloaded the data yet but will. I had refilled the auto trans with Redline DT6 because it claimed the best viscosity I could find at 100o. It wasn't really long enough to get a good feel for that; while the trans got to 100o in the session it still wasn't shifting crisply as I hoped. I think I'll try a few more sessions before judging. No steering motor overheat but I'd hope not in only 1 session! But finally the suspension; it was night and day over the standard stuff and the car was a couple of seconds quicker on the same crappy tyres, which is a huge difference. I'll stick with that and get some sway bars and a mechanical diff sorted too and see how that all goes together
    • I guess it’s partially a compromise of how my car is used, wanting to be able to switch from drift to grip with track side on-car adjustment. Also partially with the way the knuckles are set there is more static camber but less dynamic camber gain. 
    • OK, so update from the track day on Friday It was a classic "an unfortunate series of events'. There were a few cars around and when i checked my mirror coming out of the fish hook I notice some smoke from the rear of mine. Looked again and it was getting much worse, I figured I'd blown a turbo or something to got off it and pulled off the racing line. However.... since it is a left hairpin into a right kink, I was on the inside of the next corner. There was a car passing me on the left and a big drop off over the ripple strip on the right......and someone had knocked the witch's hat that was on the apex about 1m onto the track. So, between those 3, I decided to mow down the cone and not damage my car/the other car. Right choice, but surprising result.  The car decided the cone was a small pedestrian so it blew the rear bonnet hinges up to protect their head in the upcoming person to car impact....I didn't see that coming and like an airbag deployment it happened super fast. Straight into the pits from there, everything was driving fine but it became clear it was a coolant leak not smoke, it was billowing up onto the windscreen. Onto the trailer and home. I'll do a separate thread about the repair (once I work out what it is ), but the immediate problem was the bonnet wouldn't open because the front was pinched onto the front bar and would not release. Ultimately we unbolted the hinge from the bonnet, pulled it back a little and it released from the front OK. "There's your problem", the top radiator hose had popped off at the radiator.
×
×
  • Create New...